Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and have
been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from shipping or
the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to the
factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this,
all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be
used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
Place the unit on a flat surface and in a suitably large area. Make sure to apply the unit’s brakes.
Check if all drain valves are closed.
Pour the bubble liquid into the flumes, level by level. Fill up to the marked line, don’t over fill as this can permanently damage the machine.
Connect the machine to the power outlet via the supplied power cord.
Turn on the unit, put the power switch to the “ON” position. The LCD display will show “READY”.
To start producing bubbles, press “LOCK” on screen then select output level “UP” or “DOWN”. To stop producing bubbles press “LOCK” again.
Use the single level power switches to turn ON/OFF a single level.
Turn off the unit, put the power switch to the “OFF” position.
Before transporting the unit, empty the fluid flumes by opening the drain valves.
Use only original Beamz bubble liquid! (Beamz reference 160.574, 160.575, 160.577 and 160.689). Warranty will be voided if any other type of
liquid is used, improper use of liquid may lead to machine failure and malfunction.
When display shows “READY”, you can start producing bubbles and adjust the settings via LCD display panel.
