- 3 -
Warning:
- The fazermachine must be placed at least 100 cm away from inflammable materials such as curtains, books,
etc. Make sure that the housing cannot be touched by accident.
- Use only Beamz water-based fluid recommended by your dealer.
- Poor liquid caused permanent damage, bad effect, clogging, spitting of unevaporated liquid etc.
- Never add flammable fluids (oil, gas, perfume) to the fog liquid.
- Always keep enough liquid in the tank.
Use of the device without liquid will cause damage to the pump and heater.
- Do not obstruct the openings on top of the case to guarantee a good ventilation.
- Don’t put any objects on the fazer machine.
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the fazermachine
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It
needs to be repaired by a qualified technician.
- Only connect this unit to an earthed mains outlet of 220-240Vac/50Hz .
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please
let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a
steel cable, etc. which has to be fastened separately from the mounting bracket.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings
must be fulfilled.
- Keep out of the reach of children.
Location
Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied
holder and fixing screws.
Installation and Use
Unpack the fazer machine. Fill the fluid tank by means of a funnel. Plug the unit into a mains outlet. Thus the
heating element is automatically switched on. Depending on the room temperature, it takes about 4 minutes
until the working temperature is reached. Then the thermostat is clicking and the LED on the manual control
lights up. Push the switch once and the fazer machine will produce a nice thick fog. Once the fazer machine has
reached its working temperature (the LED is lit) the fazer machine can produce fog continuously. After this
period of time, the fog generator is cooled so much down that the thermostat switches off. Wait a while until the
working temperature is reached again. It is recommended to produce haze with small pauses in between so that
the temperature is maintained and the thermostat doesn’t switch off.
Make sure that there is always enough liquid contained in the tank. Use of the fazer machine without liquid can
permanently damage the unit. Once the fazer machine generates little haze or pump generate another 'rattling'
sound i turn off the unit direct. Check the fluid level and fill the tank when it is empty, check the hose and filter
blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists, switch unit
direct off to prevent further damage and contact your dealer.
