1.0 OPERATION GUIDE
GENERAL
This unit allows you to program 12 fixture of 16 DMX channels, 30 banks of 8 programmable scenes, 6 chases of 240
programmed scenes using 8 faders and other function buttons. To tailor your special effect lighting, this unit enables you to
assign or reverse the DMX channels. In addition, two or more units can communicate with each other so that they can send or
receive file dump.
Display Information
The LCD Display contains a maximum of 2x8 characters.
LCD Display Message
Chase 5 Chase 5 is activated.
Step 002 The 2nd step of a chase
Data 151 DMX value(000-255)
SP: 1M36S The current speed is 1 minute and 36 seconds
TP: 5.32S The time of the last two taps is 5.32 seconds
FT: 10.5S Fade time is 10.5 seconds
ASS 07 08 Assign DMX channels 7 and 8
RES 10 13 Reverse DMX channels 10 and 13
SN 6 Scene 6
BK 03 Bank 03
1.1 PROGRAM ENABLE
When the power is turned on, this unit enters Manual mode automatically. Press the Program
button for three seconds to activate Program mode, a fast blinking light in the Segment Display
next to "PROG." Indicates its selection.
1.2 PROGRAMMING SCENES
1. Enter Program mode.
2. Press the Fixtures button to turn on its fader control, which is indicated by the lit LED. You may
select several scanners at a time by tapping of these Fixtures buttons, so you can assign several
fixtures at a time with this unit.
3. Create a desired scene using the faders. The DMX value is 0 when the fader is fully down(bottom)
and 255 when it is fully up(top).
4. If necessary, you may tap the Page Select button to control the second set of 8 DMX
channels.
5. Once the scene is satisfactory, tap the ADD button to program this scene into memory.
