REMOTE CONTROLLER
To switch off the lights:
Press OFF on the remote control [1].
Manual Color Control:
You can set R/G/B colours with the remote by pushing either the Red <R> button for red, the
Green <G> button for green, the Blue <B> button for blue, the White <W> button for white, the
Amber <A> button for Amber, the Uv <UV> button for UV [3].
Preset colour mode:
Press one of the nine preset colours on the remote control. [4]
Program:
Press one of the four program buttons to choose between the different auto programs [5]. Speed
can be changed with up and down button [1].
The remote control is supplied with a battery inserted. An insulating foil between
the battery and the battery contacts prevents the battery from being discharged
during storage. Prior to the first operation remove the foil from the battery support
on the rear side of the remote control. Otherwise operation of the remote control is
not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear
side of the remote control press the small bar with the groove to the right (1) and at the same
time remove the battery support (2). For operation, one 3 V button cell type CR 2025 is
required. When inserting, pay attention that the positive pole of the button cell shows upwards
in the support.
WIRELESS DMX CONTROL
The unit can be used with wireless DMX. The wireless receiver module, functions as a receiver and transmitter of a 2.4 GHz
wireless signal. Switch DMX on wirelessly via the main menu (see menu structure, behind of the manual for more information).
Then establish a wireless connection with the Beamz BPP Wireless DMX Transmitter (154.077).
CAUTION! The BPP Wireless DMX Transmitter and unit must be connected on the same DMX Universe, you can check easily by
the colour of LED indicator.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure: Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit’s optics.
• Make sure the area below the installation place is free from unwanted persons during servicing
• Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
• The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
• In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
• The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
• Clean with soft cloth using normal glass cleaning fluid.
• Always dry the parts carefully.
• Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
