IMPORTANT!
KEEP THIS INSTRUCTION MANUAL
FOR FUTURE REFERENCE
WARNING
• Never leave a child unattended.
• Never use for a child able to sit up unassisted.
• This bouncer is not intended for long periods of sleep.
• This bouncer does not replace a Moses basket or a cot. When baby needs to sleep, place him or her in a suitable Moses basket or cot.
• It is dangerous to place this bouncer on an elevated surface: a table for example.
• Always use the restraint system.
• This bouncer has been designed for a child of 9kg maximum.
• Do not use the bouncer if any of the parts are broken or missing.
• Do not use any accessories or spare parts other than those approved by the manufacturer.
• Never carry the bouncer with your child in it.
• Always ensure that the locking mechanisms are fully secured.
• Always check the state of the product before use.
• Always keep the bouncer away from naked flames and other sources of heat (such as electric or gas heating devices), as well as any objects which the
child may be able to reach.
• This product must be assembled and handled by an adult.
• Use only on a flat and stable surface.
• Never adjust the height of the bouncer with the child in it.
WASHING INSTRUCTIONS FOR THE COVER
AND THE NEWBORN PILLOW
• Clean the plastic parts regularly with a damp cloth and a neutral cleaning product. Never use a solvent or any similar product.
• Always dry the product’s metal parts in order to prevent the formation of rust.
• Protect the product from atmospheric agents (rain, snow, etc.).
• Store the product in a dry place.
• The cover must be hand washed and left to dry flat. The newborn pillow is machine washable at 30°.
ASSEMBLY INSTRUCTIONS
Place the small tubes (B) on the frame (F). In order to avoid assembling the product incorrectly, always ensure that the polari-
sing slots are aligned correctly.
Position the knuckles (C). Always ensure that the knuckle is placed in the same direction as the tube and that the nut hole on
the knuckle is facing towards the inside of the bouncer.
Fasten the knuckles (C) and the small tubes (B) to the frame with the screws (D). Place the nut in the hole designed for this
purpose. Fasten the nut and screw in place with the assembly key (J). Before using, always ensure that the screws are
tightened properly.
1
2
