ELECTRICAL REQUIREMENTS
WARNING: THIS APPLIANCE MUST BE EARTHED
Electrical installation must comply with all relevant local and
national regulations. Make sure that the voltage supply is the same
as the rating given on the data plate positioned on the lower part
of the front of the oven.
This appliance must be connected to an a.c. single phase 230 V -
50Hz electricity supply.
Fit an all-pole On/Off switch between the appliance and the power
supply with minimum contact separation of 3 mm. The switch
must be of easy access once the appliance is in place for main-
tenance and service purposes.
This appliance is supplied without a connection cable. A suitable
cable which complies with all local and national regulations must
be used, and to be in accordance with the details shown on page 22.
The connection clamp for the cable is at the rear of the appliance.
Unscrew and remove the cover, then insert the cable by way of
the cable clip and connect according to the drawing on next page.
The earth wire of the power supply cable must be longer than the
positive and negative conductors. Tighten the cable clip screws
and close the cover.
Maintenance and servicing work must only be carried out after
the power supply has been disconnected, either by switching off
at the wall socket or disconnecting at the main fuse box.
10
