302156
4
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
9
Contents
Quick Reference Guide
Programme Chart
Preparing the Laundry
Selecting a Programme and Options
Starting and Completing a Programme
Changing a Programme
Interrupting a Programme
Daily Maintenance and Cleaning
Instructions for Use
Booklet
Before Using the Dryer / Connections
Electrical connection
Precautions and General Recommendations
Description of the Dryer
Vent Connection
Door Reversibility
Troubleshooting Guide / After-Sales Service
10
Before Using the Dryer / Connections
1. Removing the packaging
and check
After unpacking, make sure
that the dryer is undamaged.
If in doubt, do not use the
dryer. Contact After-Sales
Service or your local retailer.
Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, as they are
potentially dangerous.
2. Electrical Connections
Electrical connections must
be carried out by a qualified
technician in compliance
with the manufacturer’s
instructions and current
standard safety regulations.
Electrical connection must
comply with local Electricity
Board regulations.
Voltage information, power
consumption and the
required fuse protection is
shown on the rating plate
mounted at the rear of the
dryer.
The manufacturer cannot
accept any liability for
personal injury or damage to
property resulting from
failure to adhere to these
instructions.
The dryer must be earthed as
prescribed by law.
Do not use extension leads or
multiple adaptors.
Before any maintenance on
the dryer disconnect it from
the mains supply.
Do not operate the dryer if it
has been damaged during
transport. Contact one of our
After-Sales Service
technicians.
Mains cables must be
replaced by an original cable
and is only to be carried out
by a technician from After-
Sales Service or an authorized
electrician.
After installation access to
the mains plug has to be
guaranteed, or the all-pole
disconnection has to be
possible with a switch.
3. Installation
Do not install your dryer
where it can be subject to
extreme conditions, such as:
poor ventilation,
temperatures around
freezing (or above 35°C).
Remove the protective foil
from the control panel.
Stability:
When installing the dryer
always carefully level the
dryer adjusting the two feet
and check the correct
levelling with a spirit level.
To built in the dryer
For security reason do not
remove the worktop.
Connect the dryer to an
external ventilation system in
order to prevent steam from
damaging your furniture
during the years.
Stacking kit
Your dryer can be stacked on
top of your front loading
washing machine.
To do this, use stacking kit
AMH 752, available at your
dealer.
Minimum housing
dimensions:
Width: 600 mm
Height: 850 mm
Depth: 560 mm
11
Electrical connection
1) For Great Britain only
Warning - this appliance
must be earthed
Fuse replacement
If the mains lead of this
appliance is fitted with a
BS 1363A 13amp fused plug,
to change a fuse in this type
of plug use an A.S.T.A.
approved fuse to BS 1362
type and proceed as follows:
1.
Remove the fuse cover (
A
)
and fuse (
B
).
2.
Fit replacement 13A fuse into
fuse cover.
3.
Refit both into plug.
Important:
The fuse cover must be
refitted when changing a
fuse and if the fuse cover is
lost the plug must not be
used until a correct
replacement is fitted.
Correct replacement are
identified by the colour
insert or the colour
embossed in words on the
base of the plug.
Replacement fuse covers are
available from your local
electrical store.
2) For the Republic of
Ireland only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth type.
3) Socket outlet / plug
(valid for both
countries)
If the fitted plug is not suitable
for your socket outlet, Please
contact Whirlpool Service for
further instruction. Please do
not attempt to change plug
yourself. This procedure needs
to be carried out by a qualified
Whirlpool technician in
compliance with the
manufactures instructions and
current standard safety
regulations.
12
Precautions and General Recommendations
1. Packing
The packing box may be fully
recycled as confirmed by the
recycling symbol.
2. Energy saving tips
Always dry a full load:
depending on the type of
laundry and the programme/
drying time.
By preference use the
maximum spin speed allowed
by your washing machine,
since draining the water
mechanically requires less
energy.
Do not overdry the laundry.
Clean the lint filter after
every
drying cycle.
Place your dryer in a room
with a temperature between
15° C and 20° C. In case of
higher temperature ventilate
the room.
Always select the correct
programme/drying time for
the load in order to obtain
the desired drying results.
Select the
gentle
option only
with small loads.
When drying cotton, for
example: dry
iron dry
and
cupboard dry
loads together.
Start with the
iron dry
programme/drying time
setting, remove the laundry
to be ironed at the end of
that cycle and dry the
remainder of the load on the
cupboard dry
setting.
3. Disposing of packaging
and old appliances
The dryer is built from
reusable materials. The dryer
must be disposed of in
compliance with local waste
disposal regulations.
Before scrapping, cut off the
power cable so that the dryer
cannot be connected to the
mains.
4. Child safety
Children must not be allowed
to play with the dryer.
5. General
recommendations
Always set the programme/
time selector knob to the “0”
position after use. This
prevents the dryer from
being switched on
accidentally.
Before cleaning or carrying
out maintenance, switch off
the dryer and disconnect it
from the mains supply.
To clean the outside of the
dryer, use a neutral
detergent and a damp cloth.
Do not use abrasive
detergents.
Clean the lint filter at
the end of every drying
cycle:
1.
Open the door.
2.
Pull the filter upwards.
3.
Remove lint using a soft
brush or your fingertips.
4.
Push the filter firmly back
into place.
Wipe away lint from the door
seal and the door using a
damp cloth.
If the lint filter mesh is
clogged, clean it with water
and a soft brush.
If necessary, the power cable
may be replaced with an
identical one obtained from
our After-Sales Service. The
power cable must only be
replaced by a qualified
technician.
EC Declaration of
Conformity
This dryer has been designed,
constructed and distributed
in compliance with the safety
requirements of EC
Directives:
73/23/EEC Low Voltage
Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking
Directive.
The dryer must be used in
the household for the
described uses.
13
Description of the Dryer
A.
Work top
B.
Contact pin
C.
Door
To open the door: pull the
handle.
To close the door: push
gently until closed.
D.
Filter
Reminder - Maintenance
and Cleaning
Filter
Clean the lint filter at the
end of every drying cycle:
Open the door.
Pull the filter upwards.
Remove lint using a soft
brush or your fingertips.
A
B
C
D
14
Vent Connection
In some dryer models the vent
hose together with an adaptor
is supplied in the drum. If the
hose and adaptor are not
supplied as a standard the
optional accessory AMH 577 kit,
available at your dealer, can be
used.
Installing the vent hose
A.
Place a towel or the packing
material on the right-hand
side next to the dryer.
B.
Place the dryer on its right-
hand side (seen from the
front) on the towel or the
packing material.
C.
Push the adapter into the
hose (see illustration). Attach
the air vent hose adapter to
the connection located under
the dryer and lock it by
means of the foreseen lugs.
Venting outside
Without kinking it, lead the
vent hose outside (inside
diameter 10 cm, maximum
length with two bends 3 m).
Ensure that the vent hose
does not sag when stacking
the dryer on a washing
machine. It should only be
placed horizontally or
upwards.
Do not connect to ventilation
systems protected by fly nets.
These can become clogged
and cause malfunctioning of
the dryer.
Never connect the air vent
hose to a chimney or to a
mechanical ventilation
extractor duct.
Do not connect the vent hose
to the heating system. Only
connect the hose to
ventilation systems insulated
against humidity.
Dryer operation without
vent hose
Only use the dryer in a large,
well-ventilated room.
Keep the room free of dust.
A minimum distance of
10 cm between rear of
appliance and the wall must
be observed.
Dryer placed close to the
wall; venting to the left or
right
Install the dryer by using the
bi-directional kit AMH 869,
available at your dealer, should
be used.
C
15
Door Reversibility
Door Reversibility
A.Unplug the dryer.
B.
Open the door.
C.
Using a spanner, turn the
contact pin on the inside of
the door (top) through 90°
and remove it.
D.
Remove the 2 door hinge
screws, followed by the door.
E.
Unscrew the 2 screws above
and below the door lock
system.
F.
Removing the door lock:
using a screwdriver, press
down on the small rib in the
upper opening and extract
the door lock by pulling it
towards you.
G.
Reverse the door:
H.
Fasten the door on the
desired side using the 2
screws.
I.
Insert the door lock system on
the opposite side and lock it
securely.
J.
Fix the 2 screws above and
below the door lock system.
K.
Replace the contact pin in the
inside of the door (top).
F
E
E
C
D
C
16
Troubleshooting Guide / After-Sales Service
Troubleshooting Guide
If a fault occurs, before
contacting our After-Sales
Service, make the following
checks to try and remedy
the problem:
Drying takes too long /
laundry is not dry enough:
Was the correct programme
selected?
Was the inserted laundry too
wet (Washing machine spin
speed less than 800 rpm)?
Is the lint filter dirty (filter
indicator lamp on)?
The dryer does not operate:
(following a power failure
and/or interruption to the
mains supply, always press
the Start button).
Is the plug properly inserted
into the mains electricity
socket?
Is there a power failure?
Has the fuse blown?
Is the door well closed?
Has the programme been
selected?
Has the start delay option
been selected?
Has the
Start/Pause
button
been pressed?
Lint filter indicator lamp on:
Is the lint filter clean?
Is the vent hose blocked?
After-Sales Service
If, after carrying out the
above checks the
malfunction persists or
appears again, turn the
dryer off and call our After-
Sales Service (refer to
guarantee).
Please specify:
The nature of the fault.
The dryer type and model.
The service code (the number
after the word Service on the
adhesive rating plate) on the
right-hand side when the
door is open.
Your full address and phone
number.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht trad 6246 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht trad 6246 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,28 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

Andere handleiding(en) van Bauknecht trad 6246

Bauknecht trad 6246 Gebruiksaanwijzing - Nederlands - 7 pagina's

Bauknecht trad 6246 Gebruiksaanwijzing - Deutsch - 7 pagina's

Bauknecht trad 6246 Gebruiksaanwijzing - Français - 7 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info