INSTRUCTIONS FOR USE
PRECAUTIONS AND ADVICE
• After installation, make sure the appliance is not
resting on the power cable.
• Do not store glass containers with liquids in the appliance, as
they could burst.
• Do not eat ice cubes or ice lollies immediately after taking
them out of the appliance, since they could cause cold burns.
• Before carrying out any maintenance or cleaning operation,
unplug the appliance or disconnect the electrical power
supply.
• Do not install the appliance in places exposed to direct
sunlight or near heat sources, as this will result in higher
energy consumption.
• Do not store or use petrol or other flammable liquids and
gases in the vicinity of this or other electrical appliances. The
fumes can create a fire hazard or explosion.
• Install and level the appliance on a floor able to take its weight
and in a place suitable for its size and use.
• Install the appliance in a dry and well-ventilated place. The
appliance is arranged for use in places with temperatures
inside the following ranges defined according to the climatic
class given on the dataplate located on the back. The
appliance may not work properly if left for a long time at
temperatures outside the range provided for.
• It is advisable to leave the appliance connected, even if empty
even for short periods.
• Be careful not to damage the floors (e.g. parquet) when
moving the appliance. To facilitate moving, it is advisable to
empty the appliance beforehand, if possible.
• Do not use mechanical devices or any means other than
those recommended by the manufacturer to speed up the
defrosting process.
• Do not use electrical appliances inside it, unless they are of
the type recommended by the manufacturer.
• This appliance is not intended for use by people
(including children) with limited physical, sensory or
mental abilities or without experience and knowledge
of it, unless they are supervised or instructed in its use
by a person responsible for their safety.
• To prevent the risk of children becoming trapped and
suffocating, do not let them play or hide inside the
appliance.
• The power cable must only be replaced by an
authorised person.
• Do not use extension leads or multi-adapters.
• It must be possible to disconnect the power supply by
unplugging or by means of a double-pole mains switch
installed ahead of the socket.
• Make sure the voltage specified on dataplate matches
the voltage in your home.
• Do not swallow the liquid (non-toxic) contained in the
ice packs (if provided).
•
Limit the number of times the appliance door is opened.
DEFROSTING THE APPLIANCE
The appliance should be defrosted
when the thickness of ice on the
walls reaches 5-6 mm.
• Disconnect the appliance from
the mains power supply.
• Remove the packs of food from
the appliance and wrap them close
together in newspaper and store in
a very cool place or thermally
insulated bag.
• Leave the appliance lid open.
• Remove the internal defrost water drain plug (depending on
model).
• Remove the external defrost water drain plug (depending on
model) and reposition it as shown in the figure.
• Place a bowl beneath the drainage channel to collect the
residual water. If available, use the divider.
• Speed up defrosting by using a spatula to detach the ice from
the appliance walls.
• Remove the ice from the bottom of the appliance.
• In order to avoid permanent damage to the appliance interior,
do not use pointed or sharp metal instruments for removing
the ice.
• Do not use abrasive products or heat up the interior
artificially.
• Dry the interior of the appliance thoroughly.
• On completion of the defrosting, refit the plug.
CARE AND MAINTENANCE
• Remove the ice from the upper edge (see the
Troubleshooting Guide).
• Clean the inside after defrosting, using a sponge dampened
with warm water and/or mild detergent.
• Clean the side motor cooling grille (depending on model).
• Remove dust from the condenser on the rear of the
appliance.
Before carrying out maintenance, unplug the appliance.
Do not use abrasive products, scourers or stain-removers
(e.g. acetone, trichloroethylene) to clean the appliance.
To obtain the best results from your appliance, carry out
cleaning and maintenance at least once a year.
CHANGING THE LID LIGHT BULB (if provided)
• Disconnect the appliance from the
mains power supply.
• Remove the diffuser by following the
sequence of steps shown in the
figure.
• Unscrew the light bulb and replace it
with an identical bulb of the same wattage and voltage.
• Refit the diffuser and plug in the appliance.
TROUBLESHOOTING GUIDE
1. The red LED flashes.
• Is there a power failure?
• Is a defrosting operation in progress?
• Is the appliance lid properly closed?
• Is the appliance placed near a heat source?
• Are the ventilation grille and condenser clean?
2. All LEDs flash at the same time.
• Contact the After-Sales Service.
3. The appliance is too noisy.
• Is the appliance perfectly horizontal?
• Is the appliance in contact with other furniture or objects that
may cause vibrations?
