592331
1
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
5019 496 01155
Before using the dishwasher, read the installation and maintenance instructions carefully!
1
GB
GSIP 6143
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, different settings, water supply temperatures, water hardness and power supply voltage.
2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:
for detailed information on the EN/Standard
loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
1. OVERVIEW
Programme selection button
Press the button (repeatedly) until the indicator lamp of the
desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme selected is
memorized.
Half Load/Multizone
Load the upper or lower rack only.
Factory setting = Wash upper and lower rack (both indicator
lamps light up)
Press once = Wash lower rack (the indicator lamp lights up)
Press twice = Wash upper rack (the indicator lamp lights up)
At the end of the programme, the most recently selected setting
remains memorised.
If the upper rack is not being washed, the “Wash lower rack”
indicator lamp should be lit.
Rotating Power Clean
This function is activated by pressing (short) the button (the
indicator lamp lights up).
High pressure with an additional jet for better washing results and
greater lower rack load flexibility. At the end of the programme, the
most recently selected setting remains memorised.
Detergent setting upon initial use and when using a different
type of detergent
Indicator lamp off = Powder/gel detergent (factory setting).
If using combined detergents, press and hold the button for 3
seconds; the indicator lamp lights up = rinse aid and salt
indicators are deactivated.
From water hardness level 5, the salt indicator remains active.
At the end of the programme, the most recently selected setting
remains memorised.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:min),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (e. g. h 01). If using a sensor
programme, a dotted line indicates that the calibration process
is underway (lasting up to 20 minutes).
In the presence of a fault indication “F.. / E..”, refer to Section 5
“What to do if...”.
Delayed Start button
Push the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each
successive touch of the button, the delayed start indicator
increases by 1 hour, and after “h 24” returns to “h 00”. Then
press the START button. The wash programme will start after
the set time.
Start/Resume button
The indicator lamp lights up during operation, flashes when the
programme is interrupted before completion and switches off
at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to interrupt
the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this indicates
a fault: see chapter 5 “What to do if...”.
Salt level indicator and rinse aid level indicator
These light up at the end of the programme if salt or rinse aid
needs topping up.
Only add just before starting a wash cycle.
Table 1.1.
Programme Table
Detergent
dispenser
Consumption
1)
P
Programmes
Additional
options
Description of programme
large small Litres kWh Minutes
1
Sensor 40-70°C
Normally or heavily soiled crockery,
including pots and pans.
X X 7-14 0.99-1.80 70-185 ±
1)
2
Pre-Rinse cold
Crockery to be washed later. 4.0 0.03 14 ±
1)
3
Glasses 40°C
Light soiling, for example glasses and
cups.
X 10.0 0.85 100 ±
1)
4
Quickwash 45°C
Lightly soiled crockery, with no dried-on
food.
X 11.0 0.80 30 ±
1)
5
Bio Normal
2)
50°C
Normally soiled crockery. Energy-saving
programme.
X X 11.0 0.98 170 ±
1)
6
Overnight 55°C
Gentle, quiet cycle for normally soiled
crockery, thanks to the lower spray
pressure (39dbA).
X X 13.0 1.20 290 ±
1)
2
Change the programme
in progress:
- Press the “Cancel/Off” button.
- (Water drains for up to 60
seconds).
- Select a new programme.
- Press the START button.
2. QUICK REFERENCE GUIDE
Detailed instructions are given on the following pages; also see section “5. What to do if...”.
1. Switch the
appliance on
3. Fill the detergent
dispenser
4. Check the rinse aid level
5. Set the water
hardness level
6. Check the salt level
7. Load the racks
8. Turn on the water
tap, close the door
9. Select a programme,
and start
Wash cycle
10.End of programme
11.Open the door
12.Turn off the water tap,
unload the racks
2. Select the right type
of detergent
Depending on the dishwasher model
The dishwasher switches on automatically when any button is pressed except for the
button. If no button is pressed within 30 seconds, the appliance switches to
Energy Saving mode.
Fill crockery: beware of hot steam! The
start indicator blinks, close the door, press
the Start button again, the programme
resumes from where it had stopped (as
happens after a power shortage as well).
Press the
programme
selection
button
from 1
to 7 times.
Programme
selection
button
Press and hold the programme
selection button + Start/Resume
button for at least three seconds.
Press the
Start/Resume
button
Start/
Resume
3
3. HOW TO USE THE APPLIANCE
HOW TO FILL THE DETERGENT DISPENSER
Only fill the detergent dispenser prior to starting a wash programme.
Only
use detergents
specially recommended for dishwashers, observing the manufacturer’s recommended dosage.
Observe the manufacturer’s safety warnings!
Press the left button (button
1
) on the dispenser to open the detergent dispenser compartments.
a. Powder/gel/tabs
Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).
Programmes without pre-wash:
Pour the entire recommended dosage into compartment
A
.
Programmes with pre-wash:
Pour 2/3 of the recommended dosage into the large compartment
A
and 1/3 into the small compartment
B
.
Dishwasher tabs should be placed, as per the manufacturer’s
recommendations, in compartment
A
.
If the “Half load” option is selected, detergent dosage should be
reduced by approximately 1/3.
b. Combined action detergents (2 in 1/3 in 1/... etc.)
Dishwasher tabs should be placed, as per the manufacturer’s
recommendations, in compartment
A
.
Shut and firmly press the detergent compartment lid shut after filling.
Detergents with rinse aid incorporated may be effective only with longer programmes. In the
case of shorter programmes, detergent residue may be a problem (if necessary, use powder
detergent). Detergents with rinse aid incorporated tend to form excess suds.
The guarantee is not applicable if faults are caused by the use of these products.
HOW TO CHECK/FILL/ADJUST RINSE AID
Not necessary when using a combined action detergent.
a. How to check the rinse aid level
Check the visual indicator
C
on the dispenser: dark = sufficient rinse aid, clear = add rinse aid.
In the case of appliances with an electric indicator on the
control panel, the rinse aid indicator lights up at the end
of the wash cycle when rinse aid needs to be added.
b. How to fill the rinse aid dispenser
Press the right button on the dispenser (button
2
) to open
the rinse aid compartment.
Fill the dispenser with rinse aid up to the “max” line
(approx. 150 ml).
Shut the lid again.
Only use rinse aids recommended for use in domestic dishwashers.
If rinse aid is accidentally spilt,
immediately
remove it to avoid the formation of excessive suds
which could cause appliance malfunctioning.
c. How to adjust the rinse aid dosage regulator:
The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less
rinse aid is dispensed (factory setting: position 4).
Press the button
2
to open the cover.
Using a coin or similar object, turn the arrow to the desired setting.
After adjusting the rinse aid setting, shut the cover again.
If the dishes often have whitish streaks: reduce the dosage by turning the dial to a lower setting
(1-3). Dishes did not dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic
dishes have more difficulty drying and a higher rinse aid setting will not improve the situation.
Button
1
Large
compartment
A
Small
compartment
B
Button
2
Indicator
C
max
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bauknecht GSIP 6143 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bauknecht GSIP 6143 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,58 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

Andere handleiding(en) van Bauknecht GSIP 6143

Bauknecht GSIP 6143 Gebruiksaanwijzing - Nederlands - 8 pagina's

Bauknecht GSIP 6143 Gebruiksaanwijzing - Deutsch - 8 pagina's

Bauknecht GSIP 6143 Gebruiksaanwijzing - Français - 8 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info