28
For the Canadian market only…
NOTICE: The Industry Canada label identifies
certified equipment. This certification means
that the equipment meets telecommunications
network protective, operational and safety
requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements
document(s). The Department does not
guarantee the equipment will operate to the
user’s satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection.
The customer should be aware that compliance
with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be
coordinated by a representative designated by
the supplier. Any repairs or alterations made by
the user to this equipment, or equipment
malfunctions, may give the
telecommunications company cause to request
the user to disconnect the equipment.
Users should ensure for their own protection
that the electrical ground connections of the
power utility, telephone lines and internal
metallic water pipe system, if present, are
connected together. This precaution may be
particularly important in rural areas.
CAUTION: Users should not attempt to make
such connections themselves, but should
contact the appropriate electric inspection
authority, or electrician, as appropriate.
NOTICE: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an
indication of the maximum number of
terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers of
all the devices does not exceed 5.
For the American market only…
This equipment complies with Part 68 of the
Federal Communications Commission (FCC)
rules for the United States.
A label is located on the underside of the base
unit containing either the FCC registration
number and Ringer Equivalence Number (REN).
You must upon request, provide the following
information to your local telephone company:
USOC Jack Type: RJ 11
REN: O.4B
Should you experience trouble with this
telephone equipment, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights, IL 60004
U.S.A.
Phone: (847) 590-4900
Main Fax: (847) 255-7805
The REN is used to determine the quantity of
devices which may be connected to the
telephone line. Excessive RENs on the
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of
the number of devices that may be connected
to a line, as determined by the total RENs,
contact the local telephone company.
If trouble is experienced with BeoCom 3, for
repair or warranty information, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights, IL 60004
U.S.A.
Phone: (847) 590-4900
Main Fax: (847) 255-7805
If the equipment is causing harm to the
telephone network, the telephone company
may request that you disconnect the
equipment until the problem is resolved.
This equipment cannot be used on public coin
phone service provided by the telephone
company. Connection to party line service is
subject to state tariffs.
Your telephone company may discontinue your
service if your equipment causes harm to the
telephone network. They will notify you in
advance of disconnection, if possible. During
notifi cation, you will be informed of your right
to file a complaint to the FCC.
Occasionally, your telephone company may
make changes in its facilities, equipment,
operation, or procedures that could affect the
operation of your equipment. If so, you will be
given advance notice of the change to give you
an opportunity to maintain uninterrupted
service.
