Your DVD player is constructed for
connection to a Bang & Olufsen
television via a 21-pin AV cable.
Follow the procedure described
below to connect your DVD player
to your television. For an overview of
the DVD player’s connection panels,
refer to page 48 and 49.
For information about sockets on
your television, refer to the Guide
enclosed with the television.
Register all equipment connected to your
television system, including the DVD player.
This is done via your television’s ‘Setup’ menu.
Refer to the Guide included with your Bang &
Olufsen television to ensure proper connection
and registration of extra equipment.
– Connect the socket marked EXT 1 on the DVD
player to the socket marked AV on your
television via the 21-pin AV cable.
– If your television is equipped with a built-in
Dolby Digital module, connect the socket
marked OPTICAL or COAX on the DVD player
to the digital input socket on your television. If
the required cable is not enclosed, it is available
from your Bang & Olufsen retailer.
– Connect the cable from your external aerial to
the signal input socket marked ANTENNA on
the DVD player. Direct the aerial signal to the
television, using the aerial cable supplied with
the DVD player. Plug one end into the aerial
socket marked TV on the DVD player and the
other end into the aerial socket marked TV on
your television.
– Finally, connect the DVD player to the mains
supply with the enclosed cable. The DVD player
is now in standby mode – indicated by the red
light in the display panel.
Note if you configure the DVD player to:
DVD or [DVD2] … The DVD player starts disc
playback directly upon source selection.
V MEM, [V.AUX] or [DVD2] … The DVD player
skips directly to the HARD DISC CONTENT
menu upon source selection while the DVD
player is in standby.
[V.AUX2] … The DVD player starts up in tuner
mode.
Connecting the DVD player
