For Add Satellite to be available, the Settings menu must be set up to four satellites in
the start of the installation.
Remove a satellite
You may be able to remove one or more satellites from your current satellite installation.
You remove the satellite and its channels. Some satellite providers do not allow removing
a satellite.
1. Press , highlight Settings and press the centre button.
2. Highlight Channels and press .
3. Highlight Satellite Installation and press the centre button.
4. Enter your child lock pin code if necessary.
5. Select Search for Satellites.
6. Select Remove Satellite. The current satellites are shown.
7. Select a satellite to remove.
8. Press to go back one step or press to leave the menu.
For Remove Satellite to be available, the Settings menu must be set up to four satellites
in the start of the installation.
Manual installation
Manual installation is intended for advanced users.
You can use manual installation to test the signal strenght of an LNB. You can test the
signal through each tuner individually, tuner 1 (Sat 1) or tuner 2 (Sat 2). Alternatively, you
can use manual installation to quickly add new channels from a satellite transponder. You
can only add channels on tuner 1 (Sat 1).
To add channels, you need to know the frequency and polarization of the transponder.
The television will install all channels of that transponder. If the transponder was installed
before, all its channels - the former and the new ones - are moved to the end of the
channel list All. You cannot use manual installation if you need to change the number of
satellites. If this is needed, you have to do a complete installation with Install Satellites.
To test an LNB or save channels from a transponder…
1. Press , highlight Settings and press the centre button.
2. Highlight Channels and press .
3. Highlight Satellite Installation and press the centre button.
4. Enter your child lock pin code if necessary.
5. Select Manual Installation.
6. Select Tuner.
7. Select the tuner you want to test.
8. If you have more than one satellite installed, select the satellite/LNB for which
you want to test or add channels.
9. Select Polarization, and then select the polarization you need.
10. If you set the Symbol Rate Mode to Manual, you can enter the symbol rate in
Symbol Rate manually.
11. Select Search. The signal strenght is shown on-screen.
12. If you want to save the channels of a new transponder, select Store.
13. Press to go back one step or press to leave the menu.
Home transponder and LNB
On some markets, you can adjust the expert settings for homing transponder and each
LNB. Only use or change these settings when a normal installation fails. If you have a non-
standard satellite product, you can use these settings to overrule the standard settings.
Some providers may give you transponder or LNB values which you can enter here.
LNB Power
82
