1. Open the front cover and raise the presser foot.
2. At the threading port, cut the looper thread that is to be replaced.
Remove thread from under the foot and the upper thread guides.
Replace cone of thread with specialty thread.
3. With machine in locked position set the looper threading port to U,
L, or C according to the looper that is being threaded.
4. Thread specialty thread into the upper thread guides, leaving an 18
inch (40cm) tail above the threading port.
5. Place the straight end of the looper threading tool into the threading
port. Push the looper threading tool until the end comes out of the
looper eye. For the chain looper, open side door of machine to see
threading tool come out of the eye of chain looper.
6. Insert the specialty thread tail into the looper threading tool eye
(fig.A). Pull the straight end of the looper threading tool through the
looper eye bringing the specialty thread with it. (fig.B)
7. Run upper looper thread under the foot and to the left, cut lower
looper thread to 4 inches (10cm) and leave it hanging loose. Cut
chain looper thread 4 inches (10cm) and place in tray. Close side
door of machine.
S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
78
Looper Threading Tool
A
B
