744778
15
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
EN
15
I CAUTION!
The maximum nominal pressure must
not exceed 8 bar. If it is higher, a
pressure reducer must be installed
upstream from the BWT Quick & Clean
lter system.
Using the BWT Quick & Clean lter
system cannot prevent the formation of
mould. Please take appropriate measu-
res to prevent mould from forming.
8. Replacing the lter cartridge
(Fig. VI)
8.1 To determine the replacement interval
The lter cartridge removes the hardness
minerals from the water. After a period of
time, depending on the water hardness and
consumption, the cartridge will become ex-
hausted. The lter cartridge therefore has to
be replaced at regular intervals. You should
therefore check the water hardness with the
enclosed test strip to identify the expected
useful life of the cartridge on the basis of the
following table.
How to proceed:
1. Remove the test strip attached to the back
of the tting and operating instructions
and take it out of its protective cover.
2. Hold the reaction eld on the test strip
under water for a few seconds. Shake
off the residual water and wait for
approximately 1 minute.
3. Now compare the colour of the reaction
eld with the colour scale on the back of
the tting and operating instructions in
order to determine how often to change
the lter.
Replacement intervals for the lter cartridge:
Hardness range Replace after
A
3 months
B
2 months
C
1 months
Please mark the identied value for future replacement
of the lter.
I CAUTION!
To ensure the effectiveness of the
lter system, you have to replace an
exhausted lter cartridge.
The replacement lter cartridges
must always be kept in their original
packaging and stored in a dry place.
The BWT Quick & Clean lter system
must never be activated during the
measurement of water hardness.
i
NOTE!
For reasons of hygiene, the lter
cartridge should always be replaced
after 3 months.
The period for replacing the lter cart-
ridge is extended in proportion when
the system is not being used or by
breaks in operation, e.g. vacations.
Optimum lter performance can be
attained with a 10-second rinse-off.
8.2 Installing and replacing the lter cartridge
1. Unscrew the base of the BWT Quick &
Clean lter housing (Fig. I) manually.
2. Remove the old lter cartridge by pulling
it out of the lter housing (Fig. J)
3. Remove the new lter cartridge from its
foil packaging and insert it into the lter
housing (Fig. K).
4. Attach the lter housing base to the lter
housing and manually screw it on rmly
(Fig.L).
15

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw BWT Quick and Clean bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van BWT Quick and Clean in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 5,41 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info