52
BT accepts no responsibility for
damage caused to your Diverse 3016
Classic handset by the use of non-
approved batteries.
No display appears
Is the handset switched on?
The battery may be flat or dead. Recharge
or replace the battery.
No dial tone
Is the telephone line cord plugged into
the phone socket and the base station?
If other handsets are registered on the
base, the outside line may already be in
use. Wait until the call is finished and
try again.
The symbol is flashing or you
cannot link up with the base station
Is the handset registered with the base
station? To register the handset, see
page 46. Is the power cable connected at
the base and the power switched on at
the wall socket?
If you press the GREEN PHONE button
whilst
is flashing, you will hear four short
If you are still experiencing difficulty,
please call the Diverse Helpline on
08457 908070.
Please note:
If you go out of range of a base station for
a long time while your handset is switched
ON, it may take more than 20 minutes to
‘find’ the base station again when you
come back within range. However, by
simply switching the handset OFF for a
moment, and then ON again, it will find
the base station within a few seconds.
beeps from the handset.
The base station or handset does
not ring
The ringer volume may be set too low,
or switched off at the base station. To
adjust the ringer volume at the handset
or base station, see pages 39 or 40
respectively.
Is the telephone line cord connected
correctly? See page 9.
Can’t get through, even though a
dialling tone can be heard
You may be set to the wrong signalling
method. To change between TONE and
PULSE dialling, see ‘Connected to a
switchboard’, page 44.
Handset beeps
Are the handset batteries low? You will
hear a beep every 30 seconds.
If is flashing?
You will hear four short beeps when you
press the PHONE button. Check you are
still in range of your base station.
Buzzing noise on my
Radio/TV/Answering Machine/PC
Diverse is too close and is causing
interference. Move it further away.
