Converse 2015 ~ 4th Edition ~ 10th September ’02 ~ 4517
8
4 Set the Ring/MW1/MW2 switch
If your switchboard provides compatible
signalling (dc voltage switching) to indicate
message waiting you will need to move the
switch to either MW1 or MW2 to enable the
indication.
Ring Message Waiting is switched off.
The Calls/Messages light indicates
incoming calls only.
MW1 Message Waiting is switched on.
The Calls/Message light will indicate both
incoming calls and when the switchboard
has taken a voice message for you. For
voice messages the lamp will flash or be
permanently on, depending on the type of
switchboard it is connected to.
MW2 Message waiting is switched on. This
setting provides the same indication as
MW1 but should only be used if MW1
results in a permanently ON light without
any voice messages waiting. This setting
corrects some line conditions.
5 Desk mounting
If preferred, you can attach the desk/wall mount
to the base of your phone to raise it up at a
convenient angle.
To wall mount,
see page 22.
Your Converse 2015 is now ready for use
SETTING UP
Helpline
If you have any difficulties setting up or using
your Converse 2015, please call the BT Converse
2015 Helpline on
0845 050 1331.
If connecting two telephone line cords:
Set the switch to Line 2. The line cord connected
to Line 1 is used for calls. The line cord
connected to Line 2 for data communications and
the data port is automatically linked to Line 2.
