528767
9
Verklein
Vergroot
Pagina terug
1/23
Pagina verder
9
5 ATTACHING THE SADDLE. Remove the three
nuts and washers from the saddle (H), figure 8, place
the saddle onto the triangular plate at the top of
the saddle post (C), refit the washers and nuts and
tighten securely.
6 ADJUSTING SADDLE HEIGHT
Loosen the saddle height control knob (D) a little,
Figure 9, turning it anti-clockwise and then pulling
it back, insert the saddle post (C) into the hole (W)
on the main body (A) and when it is at the right
height release the control knob and this will lock
into the holes on the saddle post. Tighten the
control knob by turning it clockwise.
7 FITTING THE HANDLEBAR. Line the handlebar
(LL) up with the top holes on the main post (B),
passing the hand-grip cables over the back of the
post, figure 10, take bolt (N) and washer (I) and
thread it into the top hole but only hand tight, figure
(11). Take the guard (V) and attach it as shown in
Fig.(12). Coja la maneta (S) y el casquillo separador
(K) y atornille girando en sentido de las agujas del
reloj, en el agujero inferior, figura 13.
8 FITTING THE ELECTRONIC MONITOR.
(MOD H-490). Undo screws (c) located at the back
of the monitor, then slide the monitor onto the plate
at the top of the main post, Figure 14, put the two
screws (c) back in.
Take the end of the feedback cable (x) and plug it
into the SENSOR INPUT hole (y) at the back of the
monitor, figure 15, now take the end of the hand-
grip cable and plug it into the PULSE INPUT hole
(v) .Figure 16.
MOD H-492. Undo screws (c) located at the back
of the monitor, connect cable (m), sticking up out
of the main post (B), into connector (n), located at
the back of the monitor (P) figure 17, then slide
the monitor onto the plate at the top of the main
post (B) figure 14, put the two screws (c) back in.
Take the end of the hand-grip cable (z) and plug it
into the PULSE INPUT connector (v) at the back of
the monitor, Figure 18.
9 ADJUSTING THE HANDLEBAR. Set the
handlebar (LL) so that you can pedal in a
comfortable position and, without releasing the
handlebar, tighten up handle (S) securely, figure 19.
10 EXERTION CONTROL. Mod. H-490. To
provide an even level of exertion during exercise,
this appliance is equipped with a tensioning control
(W), located on the monitor housing, offering
various exertion settings, figure 19.
To increase pedal resistance turn the tensioning
control (W) clockwise (+) until the exertion level best
suits your exercise requirements. To reduce pedal
resistance turn the tensioning control (W)
anticlockwise (-).
11 LEVELLING. Once the unit has been placed
into its final position, make sure that it sits flat on
the floor and that it is level. This can be achieved
by screwing the adjustable feet (d) up or down, as
shown in Figure 20.
12 MOVEMENT & STORAGE
The unit is equipped with wheels (f) to make it easier
to move. The wheels located at the front of your
unit make it easier to move it into a chosen position,
by lifting the rear of the unit up slightly and pushing
it, as shown in Figure 21. Store your unit in a dry
place, preferably not subject to changes in
temperature.
13 MAINS CONNECTION (Mod H-492)
Insert the jack (g) on the transformer (c) into the
connection hole (h) on the main body (A) (bottom,
rear of the machine) and then plug the transformer
into a 220 V mains supply, Figure 22.
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE.
RHYNO H490/H492 0180078 21/6/04, 09:019
9

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

BH-Fitness-H-492-Rhyno

Zoeken resetten

  • Waar kan ik het type nummer vinden
    Ik zie alleen BH fitness proacion staan Gesteld op 22-5-2023 om 15:21

    Reageer op deze vraag Misbruik melden
  • hallo weet iemand hoe ik dit kan oplossen, in mijn display verschijnt elke keer de p met een streep erdoor en dan stop mijn programma .
    groeten Cor Gesteld op 17-1-2023 om 10:00

    Reageer op deze vraag Misbruik melden
  • Hoe reset je de computer van de Rhyno hometrainer Gesteld op 6-6-2022 om 09:17

    Reageer op deze vraag Misbruik melden
  • Rhyno 492 voorbeeld batterij vervangen krijg hen niet open graag

    Gesteld op 15-1-2022 om 13:07

    Reageer op deze vraag Misbruik melden
  • Hallo ik ben Kees.
    Ik heb een Rhyno BH Fitness home trainer zonder handleiding voor het monitor gedeelte.
    Ik heb geen idee hoe ik dit operationeel kon krijgen. Hoe kom ik aan een duidelijke handleiding voor het gebruik van deze home trainer
    Gesteld op 6-4-2021 om 21:08

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw BH Fitness H 492 Rhyno bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van BH Fitness H 492 Rhyno in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 0,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info