Handleiding BEKO HB60PX (pagina 6 van 12) (Engels)

556807

Verklein

Vergroot

Pagina terug

1/12

Pagina verder

- 6 -

• Fixing to the wall

Drill the holes A referring to the distances indicated (Fig.2).

Fix the appliance to the wall and align it in horizontal posi-

tion to the wall units. When the appliance has been adjusted,

denitely x the hood using the screws A (Fig.4). For the

various installations use screws and screw anchors suited

to the type of wall (e.g. reinforced concrete, plasterboard,

etc.). If the screws and screw anchors are provided with the

product, check that they are suitable for the type of wall on

which the hood is to be xed.

• Fixing the decorative telescopic ue

Arrange the electrical power supply within the dimensions

of the decorative ue. If your appliance is to be installed in

the ducting version or in the version with external motor,

prepare the air exhaust opening. Adjust the width of the

support bracket of the upper ue (Fig.3). Then x it to the

ceiling using the screws A (Fig.3) in such a way that it is in

line with your hood and respecting the distance from the

ceiling indicated in Fig.2. Connect the ange C to the air

exhaust hole using a connection pipe (Fig.4). Insert the up-

per ue into the lower ue and rest above the frame. Extract

the upper ue up to the bracket and x it with the screws B

(Fig.3). To transform the hood from a ducting version into a

ltering version, t the charcoal lters provided referring to

the tting instructions.

• Filtering version

Install the hood and the two flues as described in the

paragraph for installation of the hood in ducting version. To

assemble the ltering ue refer to the instructions contained

in the kit. If the kit is not provided, order it from your dealer

as accessory. The lters must be applied to the suction unit

positioned inside the hood. They must be centred by turning

them 90 degrees until the stop catch is tripped (g. 7).

USE AND MAINTENANCE

• We recommend that the cooker hood is switched on before

any food is cooked. We also recommend that the appliance

is left running for 15 minutes after the food is cooked, in

order to thoroughly eliminate all contaminated air.

The eective performance of the cooker hood depends on

constant maintenance; the anti-grease lter and the active

carbon lter both require special attention.

• The anti-grease lter is used to trap any grease particles

suspended in the air, therefore is subject to saturation (the

time it takes for the lter to become saturated depends on

the way in which the appliance is used).

- To prevent potential re hazards, the anti-grease lters

should be washed a minimum of every 2 months (it is

possible to use the dishwasher for this task).

- After a few washes, the colour of the lters may change.

This does not mean they have to be replaced.

If the replacement and washing instructions are not

followed, the anti-grease lters may present a re hazard.

• The active carbon lters are used to purify the air which

is released back into the room. The lters are not washable

or re-usable and must be replaced at least once every four

months. The active carbon lter saturation level depends

on the frequency with which the appliance is used, the type

of cooking performed and the regularity with which the

anti-grease lters are cleaned.

• Clean the cooker hood frequently, both inside and outside,

using a cloth which has been dampened with denatured

alcohol or neutral, non-abrasive liquid detergents.

• The light on the cooker hood is designed for use during

cooking and not for general room illumination. Extended

use of the light reduces the average duration of the bulb.

• Replacing halogen light bulbs (Fig. 8).

To replace the halogen light bulbs B, remove the glass pane

C using a lever action on the relevant cracks.

Replace the bulbs with new ones of the same type.

Caution: do not touch the light bulb with bare hands.

•Commands: (fig.5) mechanical the key symbols are

explained below:

A = LIGHT

B = OFF

C = SPEED I

D = SPEED II

E = SPEED III

• FILTER REMOVAL

WARNING - ENSURE THE APPLIANCE IS SWITCHED OFF

AT THE MAINS BEFORE REPLACING THE BULBS AND

FILTERS.

1. remove the filters by lifting the recessed handle and lift

free from the hood frame.

2. To reinstall the filters position in the recess at the rear

and press to lock in position.

BULB REPALCEMENT

1. Remove the filters

2. Unscrew the bulb in an anti-clock wise direction.

3. After installing the correct replacement bulb, refit the

filter.

Replacement bulbs can be easily obtained from a good

electrical or DIY store.

BEFORE CALLING SERVICE/TROUBLE SHOOTING

The hood was switched on but the unit does not operate.

• Have you plugged in/switched on the power supply at

the socket?

• Check for a blown fuse/or trip.

Extraction is poor

• Check and clean the lters if required, if required, if active

lters are present replacement lters maybe required.

• Check that the exhaust ducting is not obstructed.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR

EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE

WARNINGS.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

BEKO HB60PX Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info