23
GROUND / GND
Power connection terminal to chassis ground or negative
terminal of car battery (-12 V)
+12 V
Power connection terminal to positive terminal of car battery.
FUSE
Fuse for protection of the amplifier-internal electronics against
overload or faulty operation / wrong manipulation.
L and R
Speaker output terminals for one stereo speaker pair or one single
speaker connected in bridged mode (e.g. subwoofer)
In bridged mode the minium speaker impedance is 4 Ohms!
POWER LED
Amplifier status-LED. Lit green when power is on.
PROTECT LED
Lit red when amplifier is in protect mode due to shorted speakers,
overtemperature etc.
+ INPUT L+R
Low-level RCA signal input for connection to head-unit pre-out.
INPUT GAIN
Input gain/sensitivity control allowing the matching of the amplifier
input section to the head-unit (pre-out) output voltage.
Amplification Mode Switch
Depending on the selected switch setting the amplifier operates in
Fullrange, Highpass or Lowpass mode.
FILTER FREQ.
Crossover filter frequency control allowing the setting of the res-
pective Highpass or Lowpass cut-in or cut-off frequency between
40 and 240 Hz.
Note: This control is not active when the amplification mode switch
is in the ''Fullrange'' position!
REMOTE / REM
Remote switiching contact for the automatic (remote) turn-on /
turn-off of the power amplifier from the head-unit's remote (or
antenna control) lead.
B1
CONNECTIONS AND CONTROLS AXTON C202 / C402
11
12
10
9
8
7
6
5
4
3
1 2
C202 402 502 (D+E) 30.04.2001 10:13 Uhr Seite 23