815458
67
Verklein
Vergroot
Pagina terug
1/122
Pagina verder
Operating manual Fireplace inserts slied flat + II EN 10 | Connection to ceramic flues
67
10 Connection to ceramic flues
The specifications given in advance in respect of mounting instructions and installation regulations re-
main valid (see distances, thermal insulation, exhaust pipe connection).
The appliances are particularly suitable for installation with ceramic flues. However the faultless work-
ing of the heating system is only guaranteed if the following points are observed:
Calculation of the ceramic flue
Use of suitable Materials
Compliance with maximum lengths of flue
Installation of a direct- or heating flue
Compliance with the necessary free area of the air grilles
The calculation of the ceramic flue must be made in compliance with the specified maximum flue
lengths nd according to the technical rules of the Stove- and Air Heating Constructors Association and
valid designs.
Characteristics for calculating the flue dimensions
Appliance type Exhaust gas mass flow [mg/s] Flue gas temperature at appli-
ance collar [°C]
Req’d Feed pressure at collar
[Pa]
65x S 7.3 / 7.7 / 6.8 283 / 298 / 317 12
75x S 8.1/7.7 313/300 12
75x39 SII 7.3 286 12
75x51 SII 13.07 252 13
80x64 S
80x64 SII
8.28/8.43 312/291 12
97x S 9.9 274/288 12
120x45 S 14.88 254 13
Maximum length of chamotte ceramic flues
The flue gas temperatures at the appliance collar are average temperatures over the duration of the
combustion.
Appliance type Flue length [m] Feed pressure at collar [Pa] Flue gas temperature down-
stream of the flues [ºC]
65x S 4 12 190
75x S 4 12 190
75x39 SII 4 12 190
75x51 SII 4 12 190
80x64 S
80x64 SII
4 12 190
97x S 4 12 190
120x45 S 4 12 190
The flue is constructed of refractory mineral materials. When setting up, attention must be paid to pro-
cessing that is impervious to heating gases. The ceramic flue support must be load-bearing and heat-
resistant. The installation base on which the heat exchanger is to be set up must be heat insulated in
analogy to the manner described in the section on Protection of the set up area.
The flue pipe connection must be connected gas-tight to the ceramic flue by means of plug-in steel
tubes. The connection of the pipes to the ceramic flue is preferably to be made with a premanufac-
tured connection block made of chamotte.
TIP
The steel tube/chamotte transition must be separate (expansion) and tight. The connecting pipes do
not need to be thermally insulated.
67

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II in de taal/talen: Engels als bijlage per email.

De handleiding is 14.06 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II

Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II Gebruiksaanwijzing - Deutsch - 124 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info