815458
64
Verklein
Vergroot
Pagina terug
1/122
Pagina verder
9 | Installation instructions EN Operating manual Fireplace inserts slied flat + II
64
9.11 Ceiling above the fireplace insert
G
8
11
Fig.14: Ceiling above fireplace insert
If the cavity above the fireplace insert reaches as far as the
room ceiling (8), then the latter must be protected if:
it consists of flammable components
it serves as a bearing component
The thermal insulation layer (11) (dimension G) must be ex-
ecuted in compliance with the normal regional installation
standards.
8 Room ceiling
11 Heat insulation layer
9.12 Floor in front of the fireplace insert
The floor in front of the fireplace insert must be made of flammable material. Minimum dimensions of
this non-flammable area: forward at least 50cm, to the sides at least 30cm.
9.13 Fire protection
Fire protection within the radiation area
The minimum clearance (see Technical Data) to components made of flammable construction materi-
als or flammable components as well as furniture must be observed in front and on either side of the
firebox opening! For II series models the clearance applies to the front and rear.
Fire protection outside the radiation area
From the outer surfaces of the cladding of the open fireplace insert a distance of at least 5 cm must be
maintained from components made of flammable construction materials or flammable components
and from built-in furniture. The clearance space must be so open to the air current that an accumula-
tion of heat cannot occur. Components which only cover small areas of the cladding of the open fire-
place insert (such as floors, butt-joined wall cladding and insulation layers on ceilings and walls) can be
brought up to the cladding without any gap.
9.14 Heat insulation layers and materials
Insulation layers must be made of heat insulating boards of construction material class A1 as per DIN
4102 Part 1 with a maximum application temperature of at least 700°C and a bulk density of more
than 80kg/m³. The insulation material must be marked with the appropriate insulation material code
number as per AGI-Q 132. Only the insulation materials which are listed in the following table may be
used. If other insulation materials are used for the insulation layers, these must have an appropriate
DIBT approval (German Institute for Structural Engineering Berlin) (e.g.: Promat calcium silicate
thermal insulating board “Promasil950KS”, Wolfshöher thermal insulating board “Prowolf”, Wolf-
shöher thermal insulating board “Vermilite2000”, Thermax thermal insulating board “Ther-
maxSN400”). For building external walls and ceilings to be protected that have a U-value below
0.4W/m², additional rear ventilation (see technical rules of the Stove- and Air Heating Constructors As-
sociation) will be necessary.
64

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II in de taal/talen: Engels als bijlage per email.

De handleiding is 14.06 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II

Austroflamm Fireplace inserts slied flat II - Kamineinsatz Schieb flach II Gebruiksaanwijzing - Deutsch - 124 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info