563957
7
Verklein
Vergroot
Pagina terug
1/53
Pagina verder
7 GB/IE
Before Initial Use
j Do not place the devices near sources of in-
terference such as television sets, computers,
thick walls, thermopane windows etc. Other-
wise the transmission of radio waves between
the devices may be impaired.
j Please install the devices at least 2 metres
away from sources of interference. Otherwise
the transmission of radio waves between the
devices may be severely impaired.
j Please ensure that neighbouring devices are not
operated at the same frequency of 433 MHz.
Such devices may cause interference to the
radio connection.
j Do not place the devices next to or on metal
plates. Otherwise the quality of radio wave
transmission may be reduced.
j Do not install the devices in buildings made
of reinforced concrete, e.g. airports, high-rise
buildings, factories or cellars. Otherwise the
transmission of the radio waves between the
devices may be severely impaired.
j Do not start reception of the waves in a moving
vehicle, e.g. car or train. The transmission of
the radio waves to the devices may interfere
with the electronics of the vehicles.
j In open spaces do not place the devices more
than 25 metres apart, as otherwise transmission
of the radio waves may be interrupted.
j Do not expose the devices to temperatures
below –20 °C for prolonged periods, as
otherwise this will adversely affect the trans-
mission range.
Q
Putting the Outdoor
Sensor into Operation
Removing the battery safety strip:
Note: For this procedure you need a flat-blade
screwdriver.
j Open the battery compartment cover on the
rear of the outdoor sensor by turning the
screw in an anticlockwise direction with the
flat-blade screwdriver.
j Remove the battery safety strip. The outdoor
sensor is now ready for operation and the
control LED
36
lights up briefly.
j Close the battery compartment cover and
tighten the screw in a clockwise direction.
Installing the Outdoor Sensor:
Note: For this step you need a drill.
CAUTION! DANGER OF DEATH
AND INJURY AND DANGER OF
MATERIAL DAMAGE! Please read
the operating and safety instructions of your drill
through carefully.
j
Find an appropriate place for the outdoor sensor.
Note: Please ensure that you install the
outdoor sensor within a radius of 25 m from
the weather station. Check that there are no
obstacles between the outdoor sensor and
the weather station. Otherwise there may be
interference of the transmission of data.
For wall mounting:
j Mark the drill hole on the wall.
j Drill the hole with a drill.
j Insert a suitable wall plug into the drill hole.
j Use a screwdriver to insert a suitable screw.
j Hang the outdoor sensor on the screw with
the wall mounting hole
38
.
For free standing:
j Turn the stand
43
out from the bottom of the
outdoor sensor.
Q
Putting the Weather
Station into Operation
Removing the battery safety strip:
j Open the battery compartment
34
on the
back of the weather station.
j Pull out the battery safety strip.
j Then close the battery compartment
34
.
j Press the RESET button
33
. All of the symbols
light up briefly.
As soon as the battery safety strip has been
removed, the weather station starts to receive
the radio signal.
Note: Do not change the location of the weath-
er station during reception. Otherwise there may
be interference.
For wall mounting:
j Mark the drill hole on the wall.
j Drill the hole with a drill.
j Insert a suitable wall plug into the drill hole.
j Use a screwdriver to insert a suitable screw.
j Hang the weather station on the screw with
the wall mounting hole
32
.
For free standing:
j Turn the stand
35
out from the bottom of the
weather station.
Connecting the weather station with the
outdoor sensor and the DCF radio signal:
After removal of the battery safety strip the weather
station attempts to establish a connection with
the outdoor sensor. This process may take a few
minutes. When the connection with the outdoor
sensor has been successfully established, the
selected channel symbol
22
is shown the channel
of the outdoor sensor (To change the channel of
the sensor, see “Setting the channel”). If the con-
nection with the outdoor sensor is not established
automatically, this can be done manually by
pressing TX button
42
of the sensor”.
As soon as the weather station has established a
connection with the outdoor sensor it automatically
begins to receive the DCF radio signal. This proce-
dure takes a few minutes and is shown in the LC
display by the flashing radio tower symbol
18
.
When the DCF radio signal is being successfully
received, the radio tower symbol
18
is shown
permanently in the display. If at the time of putting
the device into operation it is not possible to syn-
7

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Auriol-Z29536---IAN-55982

Zoeken resetten

  • we gebruiken onze weerstation al heel lang. Maar nu is de buitensensor kapot, hij doet niets meer. Kunt u mij een nieuwe leveren ? Gesteld op 16-3-2022 om 13:44

    Reageer op deze vraag Misbruik melden
  • Kunt u mij ook een nieuwe buitensensor leveren ? De mijne werkt niet meer ! Gesteld op 16-3-2022 om 13:39

    Reageer op deze vraag Misbruik melden
  • Mijn weerstation schakelt zeer dikwijls over van kanaal 1 naar kanaal 2, alhoewel ik maar één kanaal in gebruik heb. Hoe kan ik dat verhelpen? Gesteld op 10-3-2021 om 14:10

    Reageer op deze vraag Misbruik melden
  • Heb al enige tijd problemen met het weerstation Z 29536; het contact tussen de buitensensor is niet goed meestal 2 streepjes heeft het 2 jaar goed gedaan zowel het weerstation als de buitensensor van nieuwe batterijen voorzien, meermalen gereset. kanalen 1,2,3, geprobeerd niets helpt.
    Heeft U een oplossing? Gesteld op 26-3-2015 om 17:10

    Reageer op deze vraag Misbruik melden
    • Ik ervaar hetzelfde probleem met hetzelfde type en heb ook alles wat U hebt gedaan uitgevoerd echter ook zonder resultaat. Wie heeft het antwoord. Geantwoord op 3-5-2015 om 11:22

      Waardeer dit antwoord (11) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Auriol Z29536 - IAN 55982 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Auriol Z29536 - IAN 55982 in de taal/talen: Engels, Deens, Zweeds, Fins als bijlage per email.

De handleiding is 1,49 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Auriol Z29536 - IAN 55982

Auriol Z29536 - IAN 55982 Gebruiksaanwijzing - Nederlands, Deutsch, Français, Italiano - 45 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info