13
BT PLAYBACK
Before transmission between your BT device and the radio is possible, both devices must be coupled. This process is called
"pairing". The radio is served as a receiver, to receive music stream to play on the radio.
If you have already coupled to a BT device before, this connection will be restored automatically when both devices are in
range and BT operation has been selected on the radio. "Pairing" does not have to be repeated. This function
may need to be activated in your BT device, however.
• Push the Menu button to display the selection menu for the different operating modes.
• Use the up/down button to select the operating mode BT and push the dial switch.
• Switch your BT device to which you want to connect the radio on and activate the pairing mode here. The device
scans for BT devices in the reception range.
• When the radio is found, your BT device shows its name Audizio Rome-XXXX (the XXXX is an identification code for
your radio unit).
• Select the radio at your BT device.
• Start playback on your BT device.
• Playback now takes place using the radio.
AUX IN
You can listen to the music stored in other audio device or smart phone on the radio, through the connection to the 3.5 mm
aux-in jack on the rear side. Use the cable with both ends in 3.5 mm pin, one end to the aux-in jack on the radio, the other end
to the earphone jack on the audio device or if it has line out socket.
ALARM SETTING
Important!
In order to use the Alarm clock function, please have the radio connected with a power supply so to have the Standby mode
enabled. When the radio is turned on, press and release the [ ] button to put the radio into standby. Standby is disabled when
the radio is using internal battery.
• Choose Alarm from the main menu or press the [Alarm] button on the remote control.
• Select either Alarm 1 or Alarm 2, choose Turn on to activate the Alarm.
• Follow the alarm wizard instructions to set the alarm.
• The wizard will guide you through the settings below:
Time - Set the time for the alarm.
Sound - You can choose Wake to Tone, My Favourite as the alarm source.
Repeat - You can schedule the alarm as you desire: Everyday, Once or multiple days.
Alarm Volume - Adjust the volume of the alarm as you like by rotating the [Dial/Select] knob or [▲/▼] button on
remote.
Alarm duration - Set the duration of the alarm from the preset options ranging from 30 to 180 minutes. The radio
will be turned to standby when the selected duration of time is due.
• After the above settings are completed, press the [◄] button to exit and make sure the Alarm is turned on. You will see the
Alarm icon appeared on the display if it is activated.
Stopping Alarm/Activate the Snooze function
When the alarm goes off, press the [ ] to stop the alarm or press the [Dial/Select] knob to activate the Snooze feature.
When the Snooze is activated, the alarm is muted for 9 minutes and sounds again when the time is due. You can repeat the
process multiple times. To stop the "Snooze" function, press the [ ].
SLEEP TIMER SETTING
You can set the timer to let the radio turns off after the selected time elapsed in the range of 15 minutes to 180 minutes.
Press [ ] button on the remote control to set the timer.
You will see the icon appeared on the display if the timer is set.
