519917
11
Verklein
Vergroot
Pagina terug
1/96
Pagina verder
This does not work in Switzerland, where the
following applies:
Only hook up locomotive units used outdoors by means of
a fault-current circuit breaker.
Only start the machine when the panelling is complete
and fully closed.
Protection Class II applies only if original insulating
material is used for repairs and insulation clearances are
not altered.
Electrical safety
Danger to life and limb if not observed!
Connecting attachments must be designed in
conformance with IEC 60245-4:1980 (DIN 57 282) and
marked H 07 RN-F, or comparable models. Cross section
of wires at least 3 x 1.5 mm² up to a maximum length of
25 m. Wire cross-section at least 2.5 mm² for lengths of
more than 25 m.
Use only connecting attachments with a rubber plug
device
for severe requirements that is protected
against spraying water.
9
Check connecting attachments for defects or ageing
before using them.
Never use defective connecting attachments.
When laying the connecting attachments, be sure that
they do get crushed or bent, and that the plug-and-socket
connection does not get wet.
Do not use any provisional electrical connections.
Never bridge over protective devices or put them out of
operation.
Observe the following instruction in Switzerland:
Only hook up locomotive units used outdoors by means of
a fault-current circuit breaker.
A licensed professional electrician must make all
electrical connections and repairs, and observe local
regulations in doing so, especially those regarding protective
measures.
The manufacturer or a company designated by the
manufacturer must attend to the repair of all electrical parts
on the machine.
Start-up
Observe all safety instructions.
Setting up the machine:
Set the machine on a solid, level base.
Keep the machine from sinking into the ground or floor.
Adhere to accident prevention regulations (danger of
tipping).
When setting up the machine, make sure that the mixing
drum can be emptied without obstruction.
Switching on and off
Be sure that
- all protective devices are on the mixer and properly
mounted.
- all safety instructions are adhered to.
The on/off switch is located beneath the motor housing.
Switch the motor on and off only at the switch.
In the event of a power failure, the machine will switch off
automatically. Press the switch again to restart the
machine.
Motor protection
The motor is equipped with a thermostat. The thermostat
switches the motor off automatically in the event of overload
(overheating). The machine can be restarted after a cooling-
off period.
Concrete mixer with threephase motor
After switching on the machine, you must check the mixing
drum's direction of rotation. When you look into the mixing
drum, it must turn to the left (counter-clockwise).
(Observe directional arrow
on the mixing drum.). If the
mixing drum turns in the
opposite direction from the
arrow, the rotating direcion
can be changed by
inderting a screwdriver for
this purpose and turn left or
right while exerting a light pressure to adjust the correct
rotating direction.
Mixing
Mixer setting:
To make concrete or mortar, the mixing drum must be locked
in a specific position. Only the proper mixer setting ensures
optimal mixing results and smooth operation.
Concrete mixer with adjusting disc
Rotating level Handwheel
Hold rotating lever or handwheel tightly while
rotating.
loosen the rotating mechanism.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Atika-Profi-145-S

Zoeken resetten

  • hoe krijg ik de kuip uit het lager er zitten geen schroeven,molen is 10 jaar oud. Gesteld op 5-10-2016 om 12:45

    Reageer op deze vraag Misbruik melden
    • de plastic bescherming weghalen en dan de grootte seegerring met een seegertang verwijderen,vervolgens mits de trommel niet te vast aan de lagers zit geroest verwijderen,gr martin. Geantwoord op 5-10-2016 om 12:57

      Waardeer dit antwoord (28) Misbruik melden
    • Hoe krijg je de kuip eraf als hij vastgeroest is?
      het bovenste lager is helemaal kapot de seegering heb ik er uit maar de kuip bungelt nog steeds en komt er niet vanaf Geantwoord op 30-4-2017 om 19:19

      Waardeer dit antwoord (46) Misbruik melden
  • Hoe moet ik een kuip demonteren van een atika betonmolen profi 145 om de rollagers te vervangen?
    alvast bedankt Gesteld op 19-1-2016 om 19:30

    Reageer op deze vraag Misbruik melden
    • de beugel los draaien en de kuip er af halen hierna de resten van de rollagers verwijderen en er een nieuwe in zetten en dan weer in zijn geheel monteren
      Geantwoord op 21-1-2016 om 12:58

      Waardeer dit antwoord (49) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Atika Profi 145 S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Atika Profi 145 S in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 3,13 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info