6.5 Installation of the display deportee
Photo(1) Photo(2) Photo(3) Photo(4) Photo(5)
- The side with plug connects with the control panel (photo1)
- The other side of the signal wire. (photo2)
- Open the wiring panel and put the side without plug through the electrical box. (photo3,4)
- Insert the wiring into the designated position on the Modbus Module or PCB(without Modbus). (photo5)
6.6 Installation of the Modbus /Fluidra Connect Signal Wire
Photo(6) Photo(7) Photo(8) Photo(9)
- Open the terminal cover (photo6)
- Take the Modbus /Fluidra Connect signal wire from the accessories (photo7) and put the round end of the
signal wire into the signal wire from Modbus Module. (photo 8)
- Three wire terminal :“A+” ,“B- ”, “GND” (Photo 9)