Handleiding Aspire Nautilus GT Kit (pagina 1 van 1) (Engels)

737245

Verklein

Vergroot

Pagina terug

1/1

Pagina verder

Nautilus GT Kit User Manual

SAFETY INFORMATION

For a safe and effective use of this product and its

accessories, we advise you to read the following

instructions in full, and to strictly observe the

operating procedures indicated in this manual and

refer to the leaflet contained in the packaging of the

individual products / accessories.

This product is intended for adult smokers. This

product is not recommended for non-smokers,

young people under the legal age, pregnant or

breast feeding women and those experiencing

general ill health.

Keep the product out of reach of Children and

minors at all times

WARNINGS FOR TRANSPORT

Do not keep your device in your pocket while

switched on to avoid inadvertently activating the

vaporization device, causing irreparable damage.

COMPONENTS OF THE PRODUCT

This product is a high-tech product and its

components such as the battery, the micro USB

cable, and the tank part have been specifically

made for this product. We recommend the exclusive

use of components and accessories indicated. Use

of components and / or accessories not specifically

produced for this device may lead to a malfunction

and / or damage to the product and to the

cancellation of the guarantee.

WARNINGS BEFORE USE

Products with an internal battery leave the factory

already fully charged. Do not recharge it until the

remaining charge indicator gives the low battery

signal. (See Instructions). The use of an empty, dry

or drained tank/pod can cause immediate damage

to the internal resistance and the consequent

cancellation of the guarantee.

WARNINGS WHILE DRIVING

While driving, be sure to strictly observe the laws

and regulations of the country where you are

located; stay focusedon driving and pay attention to

traffic conditions. Do not use this product while

driving a vehicle and keep it separate from other

objects in order to avoid damage from bumps.

GENERAL WARNINGS AND LIMITATIONS OF USE

Do not bring your vape device into contact with

water or other e-liquid. Avoid exposing the device to

too low or too high temperatures (-5 °C / 50 °C).

Avoid using the product in overheated or

excessively damp environments. Keep the product

and its accessories away from heat sources. Use

only Aspire original spare parts and accessories.

Always discharge the battery completely before

recharging. Carefully read the composition of the

e-liquid before use, and do not use the product if

you are allergic to any of the components of the

e-liquid. Do not use the product if you suffer from

respiratory and / or cardiovascular system

disorders. Do not use the product during pregnancy

or lactation.

Do not ingest or swallow any part of the product or

its accessories and do not try to open or tamper

with the components of the product or its

accessories. The device does not need any flame to

light it. To avoid performance losses, disconnect the

battery from the USB charger when fully recharged,

and in the case of anomalies, smell of burnt or

abnormal deformation of one of the components of

the device or its accessories, stop using it

immediately and contact Customer Care.

Avoid direct contact of the e-liquid with the mouth

which could happen if you inhale too strong and too

frequently or if the tank is too full.

Avoid any unauthorized operations that may damage

the product. For an optimal performance of your

vape device, it would be advisable to spend at least

30 seconds between one inhalation and the next.

We recommend only to use the Aspire wall charger

supplied to charge this device and not attempt to

recharge the device with any other type of charger.

We don’t recommend using the product while

charging.

Keep the product and its accessories out of reach of

children, and dispose of the product components at

dedicated collection/disposal points. Do not discard

this product in the environment.

This product is a high-tech product. We recommend

the exclusive use of components and accessories

indicated. We do not recommend using this product

with other brands of mods.

CONTENTS:

1* Glint Mod (18650 Battery Not Included)

1* Nautilus GT Tank (2 ml )

2* Coils:

1* 0.7Ω Nautilus 2S Mesh Coil (Preinstalled)

1* 1.6Ω Nautilus BVC Coil

1* Warranty Card

1* User Manual

1* Type-C Cable

1 Set Of O-rings

COMPONENTS VIEW:

TANK FEATURES:

Very easy top fill

Tank capacity: 2.0 ml

Bottom adjustable airflow

Coil parameters:

Nautilus BVC coil 1.6Ω

Nautilus 2S mesh coil 0.7Ω (preinstalled)

Great vapor and flavor production

Diameter: 24.0 mm

Length (including mouth piece): 53.2 mm

MOD SPECIFICATIONS:

Battery type: single 18650 high rate discharge battery

Output wattage range: 1-75W

Support resistance: 0.1-3.5Ω

Adjustable continuous fire time: 1-15S

Screen: 0.91 inch OLED screen

Type-C charging port

Output mode: wattage output

Dimensions: 25*45*80 mm

Note: battery not included

COIL INSTALLATION:

1. Invert the tank and unscrew to remove the base

hardware.

2. Detach the used coil and change it with a new

one.

3. Screw the base hardware back onto the tank.

INSTRUCTIONS:

1. Click the fire button 5 times within 2 seconds to

lock or unlock the mod, when the mod is locked, the

screen will display “LOCKED CLICK 5X” for 3

seconds then remain off.

2. Pressing the fire button for 2 seconds in locked

mode will turn the system off, to turn it back on,

press the fire button 5 times rapidly.

3. When the device is on, click the fire button 3

times quickly will turn on/off the screen, when the

screen is off, the “+” and “-” buttons are not

functioning, only the fire button works.

PARAMETER SETTINGS:

1. Press “+”/“-” button to adjust the wattage value.

Press the “+”/“-” button above 0.5S, the value will

change rapidly.

2. Pressing fire button and “-” button simultaneous-

ly will lock or unlock keys, when the keys are locked,

the “+” and “-” buttons are not functioning, only the

fire button works.

3. When the screen display “OVER 10S”, press

“+”/“-” button to adjust the continuous fire time

between 1 and 15 seconds.

SAFETY FEATURES:

1. Automatic Cutoff: The preset continuous fire time is

10 seconds, after 10 seconds of continuous firing, the

device will stop firing and the screen will display “OVER

10S” for 5 seconds.

2. Open Circuit Protection: When the connected

resistance is above 9.99Ω or the tank is not connected

to the mod, press the fire button, the device will not

function and the screen will display “NO ATOMIZER”

for 5 seconds.

3. Short Circuit Protection: When the device detects a

short, it will stop firing, and the screen will display

“SHORTED” for 5 seconds.

4. Low Voltage Protection: When the battery level

drops below 3.3V, the device will not function and the

screen will display “LOW BATTERY” for 5 seconds to

remind you to charge it.

5. Overcharge Protection: When the device is fully

charged, it will stop charging to prevent overcharging

of your battery.

6. Overheat Protection: When the temperature of the

chip is above 75

°C/167 °F, the screen will display “TOO

HOT” for 5 seconds and the device will cut off.

7. Low Resistance Protection: When the resistance of

the connected coil is lower than 0.1Ω, the screen will

display "LOW RES" for 5 seconds and the device will

stop firing.

8. High Resistance Protection: When the resistance of

the connected coil is over 3.5Ω, the screen will display

"CHECK ATOMIZER" for 5 seconds and the device will

stop firing.

9. Battery Reverse Protection: When the mod detects

that the battery is incorrectly installed or that the

battery has been damaged, it will stop charging and

the screen will turn off. You will need to install the

battery correctly or replace it for a new one.

CHARGING:

1. Charging the mod via Type-C charging port, the

maximum charging current can reach up to 2A.

2. When connecting the mod to the charger, the

screen will display a growing battery icon. Once the

battery level reaches 4.2V or when it’s fully charged,

the mod will stop charging, the screen will shut off.

IMPORTANT INFORMATION ABOUT USING NICOTINE

CONTAINING E-LIQUIDS

Before using nicotine containing e-liquid the user

should read the following information carefully.

NICOTINE CONTAINING E-LIQUID:

Do not use if you are allergic to nicotine or any of the

other ingredients contained within the e-liquid (see

manufacturer’s label for full details).

WARNINGS AND PRECAUTIONS:

Nicotine containing e-liquid are not recommended for:

• Non-smokers

• Young people under the legal age;

• Pregnant or breast-feeding women; as nicotine is

known to cross the placenta and to be excreted in

breast milk;

• Those experiencing general ill health; such as heart

disease, stomach and duodenal ulcers, liver or kidney

problems, long term throat disease or difficulty

breathing due to bronchitis, emphysema or asthma;

• Those who have an overactive thyroid gland or have

a pheochromocy toma (a tumor of the adrenal gland

that can affect high blood pressure);

• Those who have diabetes, as nicotine may affect

your blood sugar levels.

• Those taking the following medication;

• Theophylline (to treat breathing problems)

• Ropinirole (to treat restless leg syndrome)

• Clozapine (to treat schizophrenia)

POSSIBLE SIDE EFFECTS:

If you inhale too much nicotine or use the product too

much you may experience one or more of the following

effects:

• Feeling faint;

• Nausea (feeling sick)

• Headache

3. To accomplish 2A charge current, we recommend to

use a wall adapter with an output of 5V/2A.

4. We recommend using only the supplied cable to

charge your mod.

5. When the mod detects the charging voltage is over

5.3V or lower than 4.8V, it will stop charging and the

screen will display “CHECK CHARGER” for 5 seconds

to remind you to check the charger.

6. If you press the fire button while charging, the

battery will stop charging to ensure safety.

• Coughing

• Irritation of the mouth or throat

• Dizziness

• Stomach discomfort

• Hiccups

• Nasal congestion

• Vomiting (being sick)

• Heart palpitations

• Abnormal heart rate

If you experience any of these side effects; including

any possible side effects not listed in this leaflet,

discontinue using the product, if the effect(s) continue

after you stop use, consult your doctor or healthcare

professional and bring this leaflet to their attention.

SAFETY NOTE:

To avoid misfiring always ensure you either lock or

switch off your device when it is not in use. Especially

when carrying your device in your pocket, bag or

purse.

WARNINGS FORREPLACEABLE BATTERIES:

• Do not use non-rechargeable batteries.

• Do not use damaged batteries or batteries with a torn

or damaged wrapper.

• Dispose of used or leaking batteriesat a dedicated

collection/disposal point.

• Replaceable batteries are not included in the

package.

MADE IN CHINA

Manufactured By Eigate

To learn more about our products and how to use,

please visit: www.aspirecig.com

Floor 1-4, Building 3, No.14 Jian'an Road, Shajing

Sub-district, Bao'an District, Shenzhen, Guangdong

Province, China

Tel: +86-755-81499783

Email: service@aspirecig.com

Shenzhen Eigate Technology Co., Ltd.

TANK FILLING:

1. Twist the top cap anticlockwise, when the dots on

the top cap are aligned with the dots on the top

hardware, you can remove the top cap.

2. Add your preferred e-liquid through the filling

hole.

3. Put the top cap back into place then twist

clockwise firmly.

TANK TUBE REPLACEMENT:

1.Unscrew to remove the tophardware.

2.Remove the used tank tube from the hollow

metal sleeve and put a new tank tube back.

3.Screw the tophardware back onto the tank.

BATTERY INSTALLATION:

• When installing a new coil, let the tank stand for 5 minutes after

filling so the cotton can be saturated with e-liquid before use.

• Do not let the tank become completely empty. Refill the tank to

avoid dry burning or damage to the coil.

510 Drip Tip

Top Cap

Top Hardware

Acrylic Tube

Coil

Hollow Metal

Sleeve

Airflow

Control Ring

Fire Button

“+” Button

Ventilation Holes

Battery Door

“-” Button

Type-C

Charging Port

0.91 Inch

OLED Screen

*Diameter of the tank refill hole.

2.5

Aspire Nautilus GT Kit Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Aspire Nautilus GT Kit

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info