309039
27
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
Page 9
ENGLISH
ENGLISH
COMMON LACOMMON LAUNDRUNDRY PRY PROBLEMSOBLEMS (CONTINUED) (CONTINUED)
ProblemProblem Possible CausePossible Cause Suggested SolutionSuggested Solution
Empty all pockets and turn inside out before laundering.
Fasten all hooks, snaps, and zippers before laundering to avoid snags.
Remove sharp buckles. Turn knits inside out.
Before washing, rinse harsh chemicals (such as battery acid, hair
care chemicals, cleaning solutions, etc.) from towels and other articles
to avoid holes in fabrics. Do not allow these unrinsed items to contact
other fabrics.
Mend all garments before laundering to prevent enlarging of rips.
These items may fray at edges from normal wear, not the washer.
Wash only in half loads and don’t wash in the same load with heavy
items, such as towels or jeans.
Rips, snags,
excess wear
Sharp objects in pockets
Hooks, snaps, zippers,
buckles
Harsh chemicals
Existing rips and tears
Permanent press items
Permanent press items should be washed in half-loads to prevent
wrinkling. If possible, use a slower spin speed.
Use lower wash temperature settings.
Excessive
wrinkling
Machine too full
Water too hot
ERRERROR MESSAOR MESSAGES – GES – W640/W660W640/W660
Error messages will display in the LED window if faults
occur while a program is in progress. The table below
defines each possible error message.
ERRERROR MESSAOR MESSAGEGE SOLSOLUTIONUTION
When this symbol flashes at the lower right corner of the display it merely means
the glass door isn’t closed securely. Close the door and try again.
0000 If this message flashes at the top right of the LED window, the machine has failed
to spin. This could be because the load is out of balance. Turn the power off
then on again. Open the door and redistribute the washing. Run the Spin
program again.
Door lock fault Call a service technician.
Foaming Run the Rinse program again.
Try using less detergent and softener.
Use low-sudsing detergents. (See page 5.)
Overflow Call a service Technician
Pressure sensor Call a service technician.
Temperature stop Call a service technician.
Thermistor Call a service technician.
Wash motor Call a service technician.
Water inlet Make sure the water tap is open.
Water outlet Check the pin trap for possible blockage. Make sure the outlet hose isn’t kinked.
To remove the message, turn the power off or change
the program.
FFAAULULT CODES – T CODES – W600/W620W600/W620
The Program Control knobs on the W600/W620 have
two fault codes: C and S. If the knob stops on one of
these, the machine detected a problem.
C PositionC Position
This indicates a problem that can probably be taken
care of without calling a service technician. Here are
some possible problems:
Power interruption.
Water not draining out.
Water not filling machine.
The machine didn’t spin.
Refer to the “Troubleshooting” section on the next page
for possible causes and solutions. If none of these
work, call a service technician.
S PositionS Position
If the knob stops on S, this indicates a mechanical
problem and you will probably need to call a service
technician.
27

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Asko-w-620

Zoeken resetten

  • De handleiding van 36 pagina's is NIET de handleiding van een W620! Gesteld op 8-9-2016 om 21:00

    Reageer op deze vraag Misbruik melden
    • Geachte heer/mevrouw,

      Vervelend te vernemen dat u de verkeerde gebruiksaanwijzing hebt ontvangen/gedownload. Uiteraard kunnen wij u helpen met het verzenden van de juiste. Mogelijk dat u ons per mail wilt benaderen via service@alluance.nl, zodat wij u hiermee verder kunnen helpen.

      Uiteraard mag u ons ook telefonisch benaderen via 038-38515850.

      Wij staan u graag te woord,

      Met vriendelijke groeten,

      Aftersales-team Alluance, Geantwoord op 9-9-2016 om 11:17

      Waardeer dit antwoord Misbruik melden
  • Telkens storing met machine geeft dan F 10. Aan, speld verwijderd zit niks meer in maar blijft stoppen met programma en geeft weer F10 Gesteld op 27-7-2016 om 10:30

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Asko w 620 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Asko w 620 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,03 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Asko w 620

Asko w 620 Gebruiksaanwijzing - English - 2 pagina's

Asko w 620 Gebruiksaanwijzing - English - 24 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info