309039
10
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
Page 10
TRTROUBLESHOOOUBLESHOOTINGTING
The door won’t open.The door won’t open.
Make sure the power to the unit is on. If the power
is on and the indicator lamp is not lit, there is no
power supply. Check that the machine is properly
plugged into the electrical outlet. If it is, the fuses
may be blown. Call a service technician.
Make sure all the water has drained out.
If there is no water in the machine and the door
won’t open in the normal manner, you should be
able to open it manually, as follows:
1. Make sure the tub is as empty as possible and
the power is turned off.
2. Using the flat edge of the liquid detergent
partition piece, a flathead screw-driver or similar
item, gently pry open the
drain pump cover.
3. Using a T20 or flathead
screwdriver, unscrew
the red plastic looped
handle.
4. Pull the handle toward
you. The door should
open.
The machine doesn’t fill.The machine doesn’t fill.
Make sure the tap to the water supply line is open.
Turn off the water supply then disconnect the inlet
hose and check to see if the strainer in the inlet
connection is blocked.
The machine won’t start.The machine won’t start.
Check that the glass door is closed securely.
Make sure the power switch is turned on.
If the power switch is on and the indicator lamp is not
lit, there is no power supply. Make sure the machine
is properly plugged into the electrical outlet.
Check the house breaker switch/fuses.
The machine will not spin.The machine will not spin.
Make sure the pin trap or outlet hose isn’t blocked.
Clean if necessary. (See page 7.)
Make sure the No Spin option is turned off.
If a load is out of balance, the washer will rotate a
few seconds to redistribute the load then attempt to
spin again. It will do this up to ten times at a high
spin speed (1000 rpm or higher). If it still isn’t
balanced, it will advance the timer with no spin.
Extreme vibration during spinExtreme vibration during spin
cycle.cycle.
Make sure the packaging and shipping supports
were removed properly. (See page 14.)
Check that the machine is level.
Adjust machine feet and tighten locknuts. (See page 14.)
Oversudsing.Oversudsing.
Too much detergent could cause suds to backup
through the detergent compartment and run down
the front of the washer onto the floor. The suds will
condensate into water and form a small puddle on the
floor. (See page 5 for detergent recommendations.)
Washer stops during cycle.Washer stops during cycle.
It is normal for the machine to pause occasionally
during operation, especially between cycles and
during the delicate wash program.
Make sure the No Spin option isn’t turned on.
If the power switch is on and the indicator lamp is
not lit, there is no power supply. Make sure the
machine is properly plugged into the electrical outlet.
Check the house breaker switch/fuses.
Foam in the final rinse water.Foam in the final rinse water.
Make sure nothing is blocking the outlet hose.
Check for kinks in the outlet hose.
Make sure the pin trap isn’t blocked. (See page 7.)
Make sure that no part of the hose (including any
joints) is less than 3/4” (15 mm) in diameter.
Water left in the machine afterWater left in the machine after
final spin.final spin.
Make sure the No Spin option isn’t turned on.
Make sure the pin trap isn’t clogged. (See page 7.)
Make sure the outlet hose isn’t clogged.
Check for kinks in the outlet hose.
Make sure that no part of the outlet hose (including
any joints) is less than 3/4” (15 mm) in diameter.
Water leaks.Water leaks.
All hoses should be inspected at least once a year.
If they show signs of cracking, they should be
replaced.
Check to see if hose connections at faucets are
tight.
Make sure the end of the outlet hose is securely
inserted into the drain receptacle.
Make sure nothing is caught between the Smart Seal
and the tank, such as apron strings, small
handkerchiefs, socks, etc.
If you should experience a problem with your washer,
you should review the following list of frequently
encountered situations. It could save you the cost and
inconvenience of a service call.
Even though the product is under warranty, if the problem
is not caused by defective workmanship or materials,
you will be charged for a service call. Refer to page 17
to determine what is and is not covered under your
warranty. If you’re still not sure, contact the ASKO
Advisory Center before you call a service technician.
10

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Asko-w-620

Zoeken resetten

  • De handleiding van 36 pagina's is NIET de handleiding van een W620! Gesteld op 8-9-2016 om 21:00

    Reageer op deze vraag Misbruik melden
    • Geachte heer/mevrouw,

      Vervelend te vernemen dat u de verkeerde gebruiksaanwijzing hebt ontvangen/gedownload. Uiteraard kunnen wij u helpen met het verzenden van de juiste. Mogelijk dat u ons per mail wilt benaderen via service@alluance.nl, zodat wij u hiermee verder kunnen helpen.

      Uiteraard mag u ons ook telefonisch benaderen via 038-38515850.

      Wij staan u graag te woord,

      Met vriendelijke groeten,

      Aftersales-team Alluance, Geantwoord op 9-9-2016 om 11:17

      Waardeer dit antwoord Misbruik melden
  • Telkens storing met machine geeft dan F 10. Aan, speld verwijderd zit niks meer in maar blijft stoppen met programma en geeft weer F10 Gesteld op 27-7-2016 om 10:30

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Asko w 620 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Asko w 620 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,03 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Asko w 620

Asko w 620 Gebruiksaanwijzing - English - 2 pagina's

Asko w 620 Gebruiksaanwijzing - English - 24 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info