- 9 -
tions in force (the yellow/green ground conductor must
not be interrupted by the switch). When the appliance
has been installed, the omnipolar switch must be easily
reachable.
USE AND MAINTENANCE
MAINTENANCE
Remove any residues of food and drops of grease from
the cooking surface using the special scraper supplied
on request (Fig.7)
Clean the heated area as thoroughly as possible using
SIDOL, STAHLFIX or similar products and a cloth/pa-
per, then rinse with water and dry with a clean cloth.
Using the special scraper (optional) immediately remove
any fragments of aluminium and plastic material that have
unintentionally melted on the heated cooking area or
residues of sugar or food with a high sugar content
(Fig.7). In this way, any damage to the cooktop surface
is prevented.
Under no circumstances use abrasive sponges or irri-
tating chemical detergents such as oven sprays or stain
removers.
USE (Fig.2)
Press key A to switch the cooker top on.
Press one of the keys in section B corresponding to the
cooking area you intend to use.
Select cooking power using the + / - keys in section C
(number 9 on the display corresponds to the maximum
temperature and 1 to the minimum).
You can disconnect the cooking area by pressing the
symbols + and - at the same time.
To prevent use or cleaning of the cooker surface by chil-
dren, it is possible to block all functions by pressing the
D key.
If the small hotplate is equipped with an extended hot-
plate ring then the second zone will activate when the
corresponding knob P is touched and held for 3 sec-
onds (fig. 2 F).
At this point the hotplate will be ignited and the tem-
perature may be regulated using the - or + knobs.
Booster:
The appliance is supplied with a Booster (only in the
cooking area indicated in fig.3A – 4A), on the basis of the
model you own.
To activate the Booster, switch the interested cooking
area on at any power level and press key P (fig. 2F). This
allows to reach higher temperatures in a short time dis-
bursing the maximum power possible. Once the function is
activated a red LED and a P will appear on the display for
ten minutes. After this time the cooking area will automati-
cally return to power level 9.
If the Booster is activated at the same time in other parts
of the cooking area, the power will be slightly lessened
until the end of functioning.
Timer:
The timer can be used for any selected area.
Select the area where you want to use the timer and
then, by pressing the E key, activate the timer and using
+ and - choose the cooking time.
Once cooking time is over, the timer switches off the
area and deactivates the selection.
An acoustic signal can be heard for 30 seconds indicating
the end of timer activation.
THE MANUFACTURER DECLINES ALL RESPONSI-
BILITY FOR EVENTUAL DAMAGES CAUSED BY
BREACHING THE ABOVE WARNINGS.
