Handleiding Ariston CP 649 FT (pagina 26 van 88) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees)

591455

Verklein

Vergroot

Pagina terug

1/88

Pagina verder

The following instructions are provided for qualified installers

so that they may accomplish installation, adjustment and

technical maintenance operations correctly and in

compliance with national current regulations and standards.

Important: the appliance should be disconnected from

the mains electricity supply before any adjustment,

maintenance, etc. is carried out. Maximum caution should

be exercised should it be necessary to keep the appliance

connected to the electricity supply.

The cookers have the following technical specifications:

Cat. II2H3+

The maximum dimensions of the appliance are given in

the figure on page 2. For trouble-free operation of appliances

installed in housing units, the minimum distances shown

in fig.4 should be observed. Adjacent surfaces and the wall

at the rear should also be able to withstand a temperature

of 65 °C

Prior to installing the cooker, 99 ÷ 155 mm high supporting

feet (provided) should be fitted into the holes to be found in

the bottom of the cooker (fig.5). These feet are screw-

adjustable and whenever necessary should be used to make

sure the cooker stands level.

Positioning

This appliance may only be installed and operated in

permanently ventilated rooms in compliance with provisions

laid down by current regulations and standards. The

following requirements must be observed:

• The appliance must discharge combustion products into

a special hood, which must be connected to a chimney,

flue pipe or directly to the outside (fig.6).

• If it is impossible to fit a hood, the use of an electric fan

is permitted, either installed on a window or on an external

wall, which must be switched on at the same time as the

appliance.

INSTRUCTIONS FOR THE INSTALLER

In a chimney stack or branched flue Directly to the outside

(exclusively for cooking appliances)

Kitchen ventilation

The air flow into the room where the appliance is installed

must be equal to the quantity of air that is required for

regular combustion of the gas and for ventilating the same

room. Air must be taken in naturally through permanent

apertures made in the outside walls of the room or through

single or branching collective ventilation ducts in

compliance with the standards in force. The air must be

taken directly from the outside, from an area far from

sources of pollution. The ventilation aperture must have

the following characteristics (fig.7A):

• total free cross section of passage of at least 6 cm² for

every kW of rated heating capacity of the appliance, with

a minimum of 100 cm² (the heating capacity is indicated

on the rating plate);

• it must be made in such a way that the aperture cannot

be obstructed both on the inside and outside of the wall;

• it must be protected, e.g. with grills, wire mesh, etc. in

such a way that the above-mentioned free section is not

reduced;

• it must be situated as near to floor level as possible.

Detail A Adjacent Room to be

room ventilated

Examples of ventilation holes Enlarging the ventilation slot

for comburant air between window and floor

fig. 7A fig.7B

The air inflow may also be obtained from an adjoining room,

provided the latter is not a bedroom or a room where there

is a risk of fire, such as warehouses, garages, fuel stores,

etc. and is ventilated in compliance with the standards in

force. Air from the adjoining room to the one to be ventilated

may be made to pass freely through permanent apertures

with a cross section at least equal to that indicated above.

These apertures may also be obtained by increasing the

gap between the door and the floor (fig.7B). If an electric

fan is used for extracting the combustion products, the

ventilation aperture must be increased in relation to its

maximum performance. The electric fan should have a

fig.5

fig.6

fig.4

Class 1 Class 2 sub-class 1

min. 50mm

min. 700mm

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Ariston CP 649 FT Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info