Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP)
or Wi-Fi Protected Access (WPA). You therefore need to enter the correct WEP or WPA code
into the radio to get it to communicate with your network.
Only the person who set up the network in the rst place knows this code; if that person is
not you then you need to nd out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code, use the
knob to select each character of the code in turn, pressing the SELECT button after each
character. Note that WEP and WPA codes are sensitive to upper and lower case characters
so you must enter them exactly.
After the nal character, use the knob to select the END character and press the SELECT
button.
The Argon iNet 1 should now be able to connect to the network.
Choosing a radio station to listen to
1. Press the SELECT button to return to the top-level menu. (Note: if you make a mistake
at any point, press the BACK button to go back to the previous screen.)
< Stations >
