EG
9
ADJUSTING THE AIR FLOW DIRECTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
NOTES
l
The flap automatically closes when the unit
is off.
l
If automatical oscillation is selected, when
the unit starts in heating operation, the fan
stops and the flap is in fixed position until
the air being blown out of the unit begins to
warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
CAUTION
You can adjust the air flow direction using the 4 flaps of
the grille frame. Chose the best position according to the
operation mode and the recommended flap position.
Press the FLAP button to select the flap function.
Fixed:
six
position
Continous
oscillations
Automatical
oscillations
FLAPS
HOW TO ADJUST THE FLAP DIRECTION
Zone «A» for cooling
and dehumidifyng
Zone «B»
for heating
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn of f the air conditioner push the
OPERATION selector with a pen until the OPERA TION
lamp is turned off.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION selector with a pen to select the desired mode
(COOL or HEAT).
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
NOTE
Operation
button
MODELS
ASIAS8
ASIBS9
MODELS
ASICS10
ASIDS13
POWER FAILURE DURING OPERATION
