9
EG
ADJUSTING THE AIR FLOW DIRECTION
HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
Left
Vertical vane
Right
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on.
Press
the FLAP button to select the flap function
Fixed:
six
position
Continous
oscillations
Automatical
oscillations
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
NOTES
l
The flap automatically closes when the unit
is off.
l
When the unit starts in heating operation,
the fan stops and the flap is in the 4 position
(if automatical oscillation is selected) until
the air being blown out of the unit begins to
warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
CAUTION
Up
Down
Flap
Air outlet
grille
HOW TO ADJUST THE FLAP DIRECTION
Zone «A»
for cooling and dehumidifyng
Zone «B»
for heating
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
CAUTION
