The remote-control and trigger inputs
The REMOTE IN input can be used to pass RC5 codes to the DV137 if it is installed in a position (or
system) where infrared cannot be used. If this is required, please contact your dealer for further
information.
The TRIGGER IN input can be used to switch the DV137 in and out of stand-by. Connecting the
trigger output of your Arcam amplier (or other compatible device), will cause the DV137 to come
out of stand-by automatically when the amplier is switched on, returning to stand-by when the
amplier is switched off. Please see your amplier handbook for further information.
In normal use there is no need to make any connections to these inputs.
Using the remote control
The functions of buttons on the remote control are described on pages 8 and
9 (CR-515) or pages 10 and 11 (CR-415).
Please keep in mind the following when using the remote control:
<
Ensure that there are no obstacles between the remote control and
the remote sensor on the DV137. The remote has a range of about
seven meters. (If the remote sensor is obscured, the remote control
input jack on the rear panel is available. Please contact your dealer
for further information.)
<
Remote operation may become unreliable if strong sunlight or
uorescent light is shining on the remote sensor of the DV137.
<
Replace the batteries when you notice a reduction in the operating
range of the remote control.
Notes on inserting the remote control batteries
<
Incorrect use of batteries can result in hazards such as leakage and
bursting.
<
Do not mix old and new batteries together.
<
Do not use different kinds of battery together—although they may
look similar, different batteries may have different voltages.
<
Ensure that the plus (+) and minus (—) ends of each battery match
the indications in the battery compartment.
<
Remove batteries from equipment that is not going to be used for a
month or more.
<
When disposing of used batteries, please comply with governmental
(or other) regulations that apply in your country or area.
Connecting to a power supply
Mains lead
The appliance is normally supplied with a moulded mains plug already tted
to the lead. Check that the plug supplied with the unit ts your supply and
that your mains supply voltage agrees with the voltage setting (115V or 230V)
indicated on the rear panel of the unit. If for any reason the plug needs to be
removed, it must be disposed of immediately and securely, as it is a potential
shock hazard when inserted into the mains socket.
If your mains supply voltage or mains plug is different, or you require a new
lead, please consult your Arcam dealer.
Plugging in
Push the plug (IEC line socket) of the power cable supplied with the unit into
the socket (POWER INLET) in the back of the unit. Make sure it is pushed in
rmly.
Put the plug on the other end of the cable into your power supply socket and
switch the socket on.
The remote control
input requires a mono
3.5mm jack, with the
tip active and the sleeve
grounded.
The remote control signals
must be in modulated RC5
format (at 36kHz), with a
voltage level of between
5V and 12V.
C. Slide and press the battery cover back
into position.
Inserting batteries into the CR-415
remote control
Inserting batteries into the CR-515
remote control
A. Open the battery compartment by
pressing the button on the back of the
remote control.
B. Insert four ‘AAA’ batteries into the
battery compartment, following the polarity
indications given inside the compartment.
C. Press the battery cover back into position.
