English
A80/P80
11
POWER (and power indicator light)
2
Switches the unit on and off. The light indicates the status of the
amplier.
When you switch your amplier on, the light glows amber for a
few seconds, during which time the speakers are disconnected.
The light changes to green when the amplier is ready for use. A
red light means the amplier is in standby mode.
The light may ash if a fault has occurred somewhere in the
system (the fault type is shown on the front panel display of
the A80). You should unplug the amplier and leave it for a few
minutes before reconnecting. If the fault cannot be cleared,
unplug your amplier and contact your Arcam dealer.
Using your P80 power amplier
NOTE: If both lights are out the amplier will appear not
to work, as all speakers are switched off. If both are on,
overloads are more likely if low impedance speakers are
connected.
SP1 and SP2
1
These buttons allow you to select and deselect the main
(SP1) and secondary (SP2) sets of speakers attached to your
amplier.
