578744
10
Verklein
Vergroot
Pagina terug
1/17
Pagina verder
E-10
Switching the A28 on
e POWER button switches the unit on and o;
alternatively, the unit can be switched in and out of
stand-by mode by pressing the
2
button on the remote
control handset.
e power light (next to the A28 Integrated Amplier
text) indicates the state of the amplier:
1. A red light means that the amplier is in stand-by
mode;
2. When you switch your amplier on, the power
light glows amber for a few seconds; during this
time the outputs are muted;
3. e light changes to green when the amplier is
ready for use.
e power light may ash if a fault has occurred –
the fault type is shown on the display. See page 15,
‘Troubleshooting’, for help in resolving fault situations.
If the fault cannot be cleared, unplug your amplier and
contact your Arcam dealer.
Changing the volume
Use the control knob to change the volume. Turn the
knob clockwise to increase the volume, anti-clockwise
to reduce it.
e output of the A28 can be silenced by pressing MUTE
on the front panel or remote control. Press MUTE for a
second time (or change the volume) to cancel the mute.
SP1 and SP2
ese buttons allow you to switch the main speakers
(connected to the lower set of speaker terminals) and
secondary speakers (connected to the upper set of
speaker terminals) on and o.
e light above each button glows if the corresponding
speakers are currently selected. If you have connected
the A28 to the speakers using the single-wired
conguration described on page 9, then the SP1 light
should be illuminated; if you have used the bi-wiring
conguration described on page 9, both SP1 and SP2
must be switched on. Note that when both lights are o,
the amplier will appear not to work, as all speakers are
disconnected.
When listening to ‘loud’ inputs, such as CDs, the
amplier may reach its full power before the display
shows 72 (maximum volume), in contrast, lower-level
inputs, such as tuners, will sound quieter for the same
volume level shown. To compensate for this, the input
levels of each source may be adjusted. is can be done
using the A28 setup menu (see page 11).
operation
Selecting an audio source
A source-selection button is used to select the source
that is connected to the input corresponding to the
button.
Listening using headphones
e headphones socket (PHONES) accepts headphones
with an impedance rating between 8 and 2k, tted
with a 6.5mm stereo jack plug.
e pre-amp. outputs and speakers are muted when
headphones are plugged in. e headphones socket is
always active, unless the volume has been muted.
Balance
In addition to the A28 setup menu (see page 11), you
can also set le-right stereo balance directly by pressing
the front-panel BALANCE button and adjusting the
balance with the control knob.
Display
e DISPLAY front panel button changes the display
brightness. ere are three brightness levels: ‘on,
dimmed’ and ‘o. If the A28 is switched o while the
display is set to ‘o, the display is set to ‘dimmed’ when
the A28 is switched on again.
Recording an audio source
e A28 allows listening to and recording from the
same source, or listening to one source whilst recording
another. e signal to be recorded is sent to both the AV
and AUX output sockets.
Selecting the source for recording
e recording outputs can be congured in two ways:
1. To record the source being listened to;
2. To record a particular (specied) source,
regardless of what is being listened to.
To record the source being listened to, press the
RECORD button and turn the control knob if necessary
until the display shows ‘REC SRC. Aer a few seconds,
the display reverts to showing the volume level, and you
are ready to record. In this conguration, selecting a
dierent input changes the source that is routed to the
recording outputs.
To record one source whilst listening to another, press
RECORD and turn the control knob until the display
shows ‘Rec ’ followed by the name of the input (Sat,
Phono, CD, Tuner, AUX or DVD) that you wish to
record from. You are now ready to record.
Press a dierent source button to change the source that
you wish to listen to – this does not alter the source that
is routed to the recording outputs.



  






 
av-ph 20
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Arcam A28 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Arcam A28 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,89 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Arcam A28

Arcam A28 Gebruiksaanwijzing - Deutsch - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info