30 Arada Farringdon 16
OPERATING INSTRUCTIONS
CATALYST
The Arada Farringdon 16kw stove is fitted with a ceramic
catalyst to aid clean burning.
The catalyst should be inspected for damage annually and
if necessary replaced. The catalyst part number can be
found in the parts list on page 33.
Only replace with a genuine Arada Catalyst
( Details on page 20 )
Catalyst Bypass Control.
The control for the catalyst bypass is on the left and right
side of the stove in the position shown in Fig 15.
Actuation is as shown on the label on the right hand side.
The bypass should be placed in the open position during
the lighting stage and prior to opening the door for
re-fuelling.
The Catalyst will be active when the thermometer
indicates 300°C or above, the bypass door should then be
closed. The stove should be run with sufficient combustion
air to maintain a temperature above this level to ensure
proper catalyst function. During re-fuelling or initial lighting
the bypass should remain open until the minimum light-off
temperature of 300°c is reach/re-established
The door/riddling tool is used to control the bypass by
insertion into the tri-lobed boss.
Always run the stove with the bypass door closed during
normal burning phase.
See Fig 17 & 18 for cutaway image of bypass actuation.
Closed Position
Open Position (Cat bypassed)
Ceramic
Catalyst
Exposed
Stove thermometer
The stove thermometer indicates when the
stove is at the correct temperature to close the
by-pass door for normal running, and re-open
for re-fuelling and/or lighting, See Fig 16.
Fig. 15.
Fig. 16.
Fig. 17.
Catalyst
Thermometer
Catalyst Bypass
Door Control
(Same Both Sides)
Bypass Door Label
Fig. 18.
