Arada Farringdon 16 2
PLEASE NOTE— Arada has a policy of continuous product development and therefore we reserve
the right to amend the specification without prior notice.
Due to printing cycles, items or options may be described before they are generally available or
after they have ceased, so please check with your retailer or dealer.
Congratulations on your choice of an Arada Stove.
Read all instructions carefully before installing your wood burning stove.
If you are in any doubt about the instruction
to install your appliance correctly, we suggest to call a professional
master installer. A wrong installation may result with a fire, burns and possible death.
Keep these instructions.
This appliance must be connect to
· A HT type factory-built chimney approved UL103 or ULC 629 with a 6 inches dia. (15.24 cm)
· A code-approved masonry chimney with a flue liner with a 6 inches diameter (15.24cm)
N.B: Be warned that local codes and rules can have more specific requirements than those
detailed in this manual.
You should consult a master installer, fire officials or local building office about restriction and
installation inspection in your area and to determine if you need to obtain a permit
Prior to installation.
Install and operate this stove only in accordance with these instruction
Applicable standards: UL 1482-22, CAN/ULC S627-22
This manual describes the installation and operation of the Arada, Farringdon 16 catalytic equipped
wood heater. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood
emission limits for wood heaters sold after May 15, 2020.
This wood heater was tested to EPA Method 28R using Crib fuel with an emissions value of 1.5g/
hr.
Under specific test conditions this heater has been shown to deliver heat at rates ranging from
8,000 to 55,000 Btu/hr 2.4 - 16kw/hr
This wood heater has a manufacturer-set minimum low burn rate that must not be altered. It is
against federal regulations to alter this setting or otherwise operate this wood heater in a manner
inconsistent with operating instructions in this manual.
This wood heater contains a catalytic combustor, which needs periodic inspection and replacement
for proper operation. It is against federal regulations to operate this wood heater in a manner
inconsistent with operating instructions in this manual, or if the catalytic element is deactivated or
removed.
We recommend our wood
burning stoves be fitted by
an installation engineer certified in the US by
The National Fireplace Institute (NFI)
And in Canada, by the Wood Energy
Technology Transfer (WETT)
