Telephone and Apple 56K Modem Information 129
Information You Need in the United Kingdom
This terminal equipment is intended for direct connection to the analogue Public Switched Telecommunications
Network and is approved for use within the United Kingdom with the following features:
m Modem facility
m Autocalling facility
m Autoanswer facility
m DTMF signaling
Operation in the absence of proceed indication or upon detection of proceed indication
This product is in conformity with relevant regulatory standards following the provisions of European Council
Directives 73/23/EEC (Low Voltage Directive) and 89/336/EEC amended by 92/31/EEC (EMC Directive).
Informationen fur Deutschland
Diese Modem-Karte ist als Endeinrichtung vorgesehen und muss an ein TAE mit F-Kodierung angeschlossen
werden. Diese Endeinrichtung ist in Konformität gemäss Niederspannungsrichtlinie 73 / 23 / EWG sowie EMC-
Richtlinien 89 / 336 / EWG und 92 / 31 / EWG.
Informations pour la France
Ce matériel est conforme aux normes applicables de sécurité éléctrique d’après la directive 73 / 23 / CEE et aux
normes applicables de comptabilité éléctromagnétique d’après la directive 89 / 336 / CEE, modifié par la directive
92 / 31 / CEE.
Information You Need in Australia
All telecommunications devices are required to be labelled as complying to the Australian telecommunications
standards, ensuring the health and safety of the operator and the integrity of the Australian telecommunications
network. To provide compliance with the Australian Communications Authority’s technical standards, please
ensure that the following AT commands are maintained:
m ATB0 (ITU/CCITT operation)
m AT&G0 (no guard tone)
m AT&P1 (33/66 pulse dial make/break ratio)
m ATS0 = 0 or ATS0 = 1 (no answer or answer greater than one ring)
m ATS6 = 95 (DTMF period between 70–255 ms)
m ATS11 = 95 (DTMF period between 70–255 ms)
For calls that are automatically generated, a total of three call attempts are allowed to a telephone number, with a
minimum period between calls of 2 seconds. If the call does not connect after three attempts, 30 minutes must
expire before automatic redialing may be initiated. Failure to set the modem (and any associated communications
software) to the above settings may result in the modem being non-compliant with Australian
telecommunications standards. Under these circumstances a user could be subject to significant penalties under
the Telecommunications Act 1997.
This modem must be properly secured in order for you to use it. Telecommunications network voltages exist
inside the computer and the telecommunications line connection must be removed before opening the
computer.
Information You Need in New Zealand
This modem is fully approved to operate on the New Zealand telecommunications network under Telepermit
number PTC 211/99/077. All telecommunications devices are required to hold a Telepermit and be labelled
accordingly with the approved Telepermit number to comply with the New Zealand telecommunications
standards, ensuring the health and safety of the operator and the integrity of the New Zealand
telecommunications network. To ensure compliance, all calls that are automatically generated should not make
more than 10 call attempts to the same number within any 30 minute period with a minimum period between
calls of 30 seconds. Failure to adhere to these standards may result in the modem being non-compliant with New
Zealand Telecom standards. Under these circumstances a user could be subject to significant penalties.
