764158
9
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
9
Release the Test button. Upon
releasing the Test button the
Power LED will flash green
once every second. This
indicates that the sampling
rate of the alarm has increased
and can be tested using a
known source of CO.
Step 3 Light an incense stick using
a match or lighter. Be sure to
blow out the flame so that the
incense stick is smouldering.
Extinguish the lighter, or put
out the match and place it into
a dish of water.
Step 4 Turn the alarm on its side so
that the vents on the right
hand side of the alarm are
pointing downwards (see
diagram opposite). Hold the
burning incense stick around
15cm (6 inches) below the
alarm, so that the smoke
enters the vents on the side of
the alarm.
Silence the loud 85dB sounder during
an alarm (only possible when current
CO level is less than 50ppm).
Testing the sounder, batteries and
circuitry
Test the sounder, batteries and circuitry
by pressing and holding the Test button
for 1 second to confirm that the alarm is
operating properly. The sounder should
sound as soon as the button is pressed,
and the Alarm LED will illuminate red,
indicating that the sounder is working and
the batteries are providing power to the
unit. This test for the sounder, batteries
and circuitry should be performed weekly.
Testing the sensor
NOTE: Aerosol CO test kits or incense
sticks may be used to test the sensor.
Alternative sources of smoke, for example
an extinguished candle or match, will
not contain sufficient levels of carbon
monoxide to obtain a response from the
alarm during this test. Please note your
CO alarm will not detect smoke.
If testing the sensor for the first time after
installation, or replacing the batteries,
make sure that the alarm has completed
the initial 3 minute warm up period and
the power LED is flashing green once
every minute.
CAUTION: Sensor testing should only be
performed by a responsible adult.
Read all steps thoroughly before
attempting to test your the sensor
Step 1 If the alarm is wall or ceiling
mounted unhook the alarm
from the screws.
Step 2 Cover the sounder vents with
one hand. Press and hold the
Test button down with your
thumb/finger until the Power
LED illuminates green and the
sounder sounds for a second
time (this should happen after
around 5 seconds).
Test Button
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw AngelEye CO-FA-AE-9B bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van AngelEye CO-FA-AE-9B in de taal/talen: Engels als bijlage per email.

De handleiding is 0,8 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info