644612
22
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
22
User’s manual
EN
ROBOT STOP
the robot stops automatically if the following conditions are detected:
•
lawn mowed: the sensor has detected that the lawn has been mowed and therefore, does not require further mowing.
Recharge the batteries and start the robot again after one or two days based on the growth of the grass.
•
no grass present: the grass sensors have not detected the presence of grass for an extended period.
•
discharged batteries: the batteries have used up their operating capacity.
•
batteries in protection: when the batteries have reached a capacity which is lower than the level of the discharged batteries,
the robot completely turns off without displaying any indication. In this case, connect the robot to the recharger. The robot will
not turn on immediately, as normally occurs, but only after a few minutes.
IN PAUSE
C. PLAY/PAUSE:
(YELLOW LED STEADY ON)
in pause / in pause due to low battery.
PLAY
OFF
ON
PAUSE
STOP
H
I
G
H
B
A
T
T
E
R
Y
L
O
W
B
A
T
T
E
R
Y
(A)
(B)
(C)
(D)
(YELLOW LED SLOW FLASHING)
Robot in standby. Press the PLAY/PAUSE
key to display the status of the LEDs.
1
(YELLOW LED 1 FLASH)
the lawn has been mowed.
2
(YELLOW LED 2 FLASHES)
no lawn present.
PROLONGED INACTIVITY AND RESTARTING
If the robot has not been used for a long period of time, it is necessary to perform a series of operations to guarantee the correct
functioning at the time of reuse.
1. Fully charge the battery before winter storage. Recharge the battery at least once every ve months.
2. Have the routine maintenance performed by an authorised dealer. This is essential for keeping the robot in good condition.
The assistance service usually includes the following operations:
•
total cleaning of the robot, the cutting blade and all the other moving parts.
•
cleaning of the inside of the robot.
•
checking of robot functioning.
•
checking and, if necessary, replacement of any worn parts such as the cutting blade.
•
checking of the battery capacity.
•
if necessary, the dealer may also load new software.
3. Accurately clean the robot (see “Robot Cleaning”).
4. Check any worn or damaged components such as the cutting blade and evaluate their replacement.
5. Store the robot in a protected and dry place with an ambient temperature between 10° and 20° C, out of reach of foreign
elements (children, animals, other foreign objects, etc.). Store the robot at a temperature below 20°C in order reduce the
automatic discharge of the batteries.
6. Disconnect the power plug from the power supply unit.
22

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Ambrogio-L50

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ambrogio L50 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ambrogio L50 in de taal/talen: Engels als bijlage per email.

De handleiding is 9,15 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Ambrogio L50

Ambrogio L50 Aanvulling / aanpassing - Nederlands - 3 pagina's

Ambrogio L50 Aanvulling / aanpassing - Nederlands - 2 pagina's

Ambrogio L50 Gebruiksaanwijzing - Nederlands - 44 pagina's

Ambrogio L50 Gebruiksaanwijzing - Deutsch - 23 pagina's

Ambrogio L50 Gebruiksaanwijzing - Deutsch - 18 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info