661845
6
Verklein
Vergroot
Pagina terug
1/26
Pagina verder
6
ENGLISH
Touch a lighted match to the exposed top edge of the wick.
Once you see that the wick has been lit, lower the burn chamber
back down over the wick.
Rotate the burner knob from side to side a few times to make sure
that the burner is positioned properly on the wick adjuster.
Then begin following the steps outlined in “Adjusting the wick”.
CAUTION: Make sure that you do not leave the match, or any portion of it (match head, etc.) in the burner area. Debris
left from the match can cause an uneven alignment of the burner and may result in smoke, incomplete combustion, odor,
or fire.
CHECKING THE IGNITION SYSTEM
If the automatic ignition system fails to operate properly, Perform the following methods:
BATTERIES -2 C cell batteries are located at the rear of the heater. Replace with new batteries.
IGNITER PLUG If the automatic ignition system still doesn’t work after replacing the batteries, check the igniter
plug. If the glow coil filament is broken, bent, or doesn’t glow when engaged via the ignition lever, it must be
replaced.
CAUTION: Be sure igniter plug is Type “B”, 2.5V DC, IA only.
To replace the igniter plug:
Remove the batteries.
Remove the 2 cabinet screws and lift off the cabinet and grille assembly.
Pull the ignition lever to raise the igniter plug.
Push the igniter plug in and turn in a clockwise direction to remove.
Install a new igniter plug (Type “B”, 2.5V DC, IA only by pushing it in and
turning it in a counter-clockwise direction.
Reassemble the heater and replace the batteries.
TEST IGNITION Using the wick adjuster knob, raise the wick to its maximum
height. Pull the ignition lever.The igniter plug should be within 1~2mm of the wick
when the ignition lever is fully engaged.
ADJUSTING THE WICK
After lighting the heater, it is important to check the heater flame within the first 5-7 minutes of operation. During the
first 5 minutes after ignition, the burner chamber warms up and flames will become visible at the top of burner. These
flames will gradually build up. After 5-7 minutes of operation, you should use the wick adjuster knob to obtain the proper
flame height. The proper flame height is a flame of no more than 1/2at the top of the burner, with an even distribution
of flame around the flame spreader disk which is positioned in the center of the top portion of the burner.
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alpina SF-9345 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alpina SF-9345 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info