626267
9
Verklein
Vergroot
Pagina terug
1/18
Pagina verder
9
GB
6. Offset (temperature adjustment)
This function calibrates the temperature on the
panel ±5 °C if you notice that the temperature is
not the same as the temperature shown on the
panel.
Applies also to display of external temperature.
7. Return
To return to the previous menu, press this
symbol.
8. Prio setting
With this function you can choose to prioritise
(select) electricity or gas as the main alternative.
9. Button sound
This function turns button sounds on and off.
10. Backlighting
Standb. Screen can be set to three different
modes, dark, bright and invert.
Dark: Used to turn of screen backlight. The
screen turns off (goes dark) in Standby. Pres-
sing the screen or the menu button while
standby is active will light up the screen but
it will return to dark again after 30 seconds
unless controlled from the panel.
Bright: Used to obtain backlight while the
screen is in standby.
Invert: Used to obtain inverted screen back-
light while it is in standby. Standby is activa-
ted automatically after 30 seconds if the
panel is not touched.
The Brightness of the screen's working mode
can be adjusted between 1-3.
11. Automatic temperature increase
(legionella)
The boiler will start at 02.00 in the morning (if
the clock is set) and run as indicated for “More
hot water” for 30 minutes (see section 5.2).
This is to reduce the risk of legionella.
12. Circulation pump settings
Pump selection: Choice of pump.
*12 V pump, pump capacity is variably adjus-
table with a potentiometer on the back of the
pump (1-5), normal mode is 2, which works in
most cases. Mounted on the boiler.
*PWM controlled 12 V pump, this is a vari-
able speed controlled pump that can be set
to ve different levels (1-5) via the panel,
normal level is 2, which works in most cases.
Mounted on the boiler
*Extra 12 V pump, often located in the
expansion tank.
*230 V pump. Often used in combination
with an extra 12 V pump located in the
expansion tank.
If you have both a 230 V pump and an extra
12 V pump installed, you will also be able to
select AUTO mode from the menu.
Auto: In this mode, the *230 V pump will
work if 230 V is connected and the extra 12
V pump is activated if 230 V is disconnected.
Pump setting: (Setting)
Cont: With this function selected the pump
is permanently on. (NB. This function limits
the supply of hot water, particularly when
there is a low heating requirement).
Therm: With this function selected the
pump is controlled by the panel/room sen-
sor. This is the normal operating mode for
heating the vehicle and obtaining a normal
supply of hot water.
13. External start
This function is used when starting the boiler
externally. When an external start has been
activated, the panel should be turned off.
External start has three modes: Off, Ext and
230 V. The function is turned off in Off mode.
*Ext. This function is used when starting the
boiler through an external signal. When the
EXT function has been activated, the control
panel’s on/off button must be turned off but
12 V must be connected (vehicle's main switch
on). Before turning off the control panel with the
on/off button, set the parameters/functions that
you want the boiler to have when it starts.
NB! In order to use this function, an
accessory must be installed that can use
external start.
*230 V. This function is used in connection
with starting the boiler when connection of
230 V to vehicle takes place externally. When
the 230 V function has been activated, the
control panel’s on/off button must be turned
off but 12 V must be connected (vehicle's
main switch on). Before turning off the control
panel with the on/off button, set the parame-
ters/functions that you want the boiler to have
when it starts (230 V connected). Certain
vehicles can be equipped with their own solu-
tion, *caravan site connector.
14. Language
This function is used to reset the screen
between different languages. Available
languages are English, French and German.
However, the service menu is only available
in English (see section 8).
Functions marked with a (*) are accessories, which are not installed on all vehicles, refer to the vehicle
manufacturer's instructions.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Alde-Compact-3020-HE---rev-1442

Zoeken resetten

  • Wij hebben een alde 3020 van 2015 en sinds kort panel failure 2 . Ze hebben bij de dealer de printplaat al vervangen . Maar nog steeds die zelfde fout . Gesteld op 5-4-2022 om 05:45

    Reageer op deze vraag Misbruik melden
  • Wij hebben net een carthago gekocht en heel de week de kachel op stroom gehad en nu zijn we onderweg en hebben wel gas op de koelkast en gasstel maar op de alde verwarming geeft hij Gas failure aan wat betekend dat Gesteld op 10-12-2020 om 20:07

    Reageer op deze vraag Misbruik melden
  • Goede middag wij hebben een alde Systeem
    Moet de boiler niet gereinigd worden vanwege kalk aanslag en waarmee !!!
    M vr gr Gesteld op 5-6-2020 om 19:04

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alde Compact 3020 HE - rev 1442 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alde Compact 3020 HE - rev 1442 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,21 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Alde Compact 3020 HE - rev 1442

Alde Compact 3020 HE - rev 1442 Gebruiksaanwijzing - Nederlands - 18 pagina's

Alde Compact 3020 HE - rev 1442 Gebruiksaanwijzing - Deutsch - 18 pagina's

Alde Compact 3020 HE - rev 1442 Gebruiksaanwijzing - Français - 18 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info