626264
10
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
The connection should be made in accordance with g
10.
240 volts (immersion heater only)
The immersion heater must always be connected to
a 240-volt earthed socket. Permanent installation of a
240-volt wallsocket must be made. Keep cables clear
of immersion heater body.
WARNING: 240 volts must be well shielded from 12
volts.
Fig 10
Terminal blockA.
Cut-out 1 amp fuseB.
Room thermostatC.
Battery 12 voltsD.
The boiler from aboveE.
FITTING THE HEATING SYSTEM3.
In order to obtain the best effect from the heating sys-
tem, the radiators should be tted along the outer walls
and under the windows. In order to obtain good air
circulation (g 11) and correct heat emission, fresh air
should be able to pass between bed bases, oor and
back cushions and outer walls (see g 12). It is there-
fore extremely important that air gains free access to
the radiators, as these are to supply the majority of the
heat to be distributed inside the vehicle. If no holes are
made for air gaps as per g 13, the radiators will not be
able to emit sufcient heat, which will lead to a sharp
fall in temperature at windows and outer walls, leading
to condensation.
Installation should be carried out using Ø 22 mm pipe
and any type of radiator. Radiators constructed of
copper piping are most efcient. Every metre of radia-
tor has a heat emission of about 400 watts. Pipes and
radiators must not be placed higher than the bottom
of the boiler’s expansion vessel. The boiler must be
raised on a plinth if there are upper alcoves, se g 12.
How many metre’s of radiator are required in the
vehicle?
The most important thing is to have a radiator under
each window that is slightly longer than the window.
A useful guide is the length of the living area x 1.5 =
the number of metres of radiators, but the greater the
length of radiator, the better and more even the heat
distribution. This allows a lower system temperature in
the boiler for the same heat emission. This saves gas
and provides a more pleasant heat. The pipes should
be run horizontally and air screws should be located at
suitable places where air cannot escape by itself, e.g.
if the pipe is run over the wheel housing. If the vehicle
has a sleeping alcove above the driver’s cab, it is very
important to locate an air screw at the highest point
(see g 12 E). All curves should be as gentle as pos-
sible, otherwise circulation is obstructed.
Make sure that radiators and pipes are properly at-
tached with brackets. As a connection between ra-
diators and pipes, short rubber connections made of
special rubber should be used. The rubber connections
should be secured with wire clips. A sealant between
the rubber connections, Permatex Form-a-Gasket no.
3 should be used. A draining valve should be tted to
the lowest point of the pipe (see g 12 F).
NB. Aluminium and copper must not be mixed in the
heating system, because the copper corrodes the
aluminium. It is even very important not to use the
same equipment for cutting and handling copper and
aluminium. If a copper shaving, for example, gets into
an aluminium pipe, it will almost certainly give rise to a
hole in the pipe.
Fig 11
Air owA.
RadiatorsB.
Fig 12
Circulation owA.
Circulation returnB.
Ventilation ductC.
RadiatorD.
Air nippleE.
Drain cockF.
Room thermostatG.
Connection to the heating system3:1
The LPG boiler’s connections to the heating system
are located on the rear of the boiler. Use the same
rubber connections, clips and sealant as for the rest of
the system.
LPG boiler with water heater type 2959 and immersion
heater should be tted in accordance with g 14.
Fig 14
Flow radiator waterA.
Return radiator waterB.
Filling the heating system3:2
The heating system must be lled with a liquid mixture
consisting of 60% water and 40% glycol. Use high
quality glycol that is designed for heating systems and
contains inhibitors. If the heating system is exposed to
temperatures lower than -25 °C, the glycol percentage
is to be increased, but it should not exceed 50%.
Vessels used to handle the liquid must be absolutely
clean, and the pipes in the heating system must be
free from contamination. This is necessary to prevent
the growth of bacteria in the system. Filling is carried
out through the expansion tank, either manually or
with the aid of Alde’s lling pump. This pump both lls
and bleeds the system. If the system is lled manually,
slowly pour the liquid until the level is approximately
1 cm over the MIN-line in the tank. Bleed the system.
Rell if the level has fallen during bleeding. A newly
lled heating system should be bled at regular intervals
during the rst few days of operation.
10
10

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Alde-Comfort-2928

Zoeken resetten

  • mijn ontsteekunit is defect waar kan ik een nieuwe kopen Gesteld op 26-7-2023 om 14:18

    Reageer op deze vraag Misbruik melden
  • avez vous une video du manuel d'utilisation en francais Gesteld op 22-12-2021 om 18:34

    Reageer op deze vraag Misbruik melden
  • Goedenmiddag de knop van het bruine temp. regelaar waar ook het schuifje van de pomp op zit doet niets meer ,hij ging eerst heel zwaar en daarna deed hij niets meer, ook hoor ik de klik bij 25 grsden niet meer als je hem daarover dtaait.het betreft de xgn lange jan type2928 comfort 1997. Heeft iemand een idee? Gesteld op 3-5-2021 om 13:43

    Reageer op deze vraag Misbruik melden
  • De regelknop op het bedieningspaneel van mijn alde 2928 comfort draait heel zwaar van de ene op de andere dag en regelt geen temeratuur meer wat kan dit zijn? Gesteld op 3-5-2021 om 13:42

    Reageer op deze vraag Misbruik melden
  • Kunnen wij onze Alde ook gebruiken op 220v er zit wel een knop voor 1000w of voor 2000w gebruik???? Gesteld op 4-8-2020 om 15:03

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alde Comfort 2928 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alde Comfort 2928 in de taal/talen: Duits, Engels, Zweeds als bijlage per email.

De handleiding is 1,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Alde Comfort 2928

Alde Comfort 2928 Gebruiksaanwijzing - Nederlands, Deutsch, English, Français, Svenska, Suomi - 32 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info