586636
1
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
Use only the supplied battery.
Remove any headset attachment (earbud excluded)
before battery replacement.
If the headset will not be used for a long time,
remove the battery to prevent possible leakage.
To purchase a replacement battery pack, contact
your Alcatel home & business phones partner. Use
only battery pack recommended by Alcatel home &
business phones.
You can register Alcatel IP70 onto the following
phones : Alcatel Temporis IP300 and Alcatel
Temporis IP700G. Both phones support one
headset only.
Register the headset with the telephone base
before use. After charged, the light on headset
ashes in red and blue slowly and alternately.
Headset charger Cordless headset
with medium-sized
earbud attached
Parts checklist Headset overview
1 – VOL+/VOL-
Push to right or left to adjust the ringer volume
while in idle mode, or the listening volume while on
a call.
2 – MUTE/FLASH
Press to mute the ringer in the earpiece when
there is an incoming call.
Press to mute the microphone during a call.
Press and hold for two seconds to answer an
incoming call when you receive a call waiting
alert during a call.
3 –
Press to make, answer or end a call.
4 – Microphone
5 – Battery pack
Open to replace the battery pack.
6 – Earpiece
Charger overview
1 – Magnetic charging mount
Place the headset here for charging.
2 – Power cord slot
3 – Power jack
Light and alert tones overview
Light:
light status
Red On when the headset is charging in the
headset charger.
Flashes every 10 seconds to indicate
the battery is low when the headset is
not in the headset charger.
Flashes three times to indicate the
headset is powering off.
Blue On when a fully charged and registered
headset is in the headset charger.
Flashes three times to indicate the
headset is powering on.
Flashes twice every three seconds
when the headset is in use.
Flashes four times every four seconds
when there is an incoming call.
Flashes every 10 seconds when a fully
charged and registered headset in idle
mode is out of the headset charger.
Red
and
blue
Flashes slowly when the headset is not
registered.
Flashes quickly when the headset is
trying to register to a telephone base.
Off No battery is installed or out of battery.
The headset is powered off.
Alert tones:
One short beep Headset key tone.
One short beep
every 30 seconds
Muted headset microphone
alert tone.
Two beeps Error alert tone.
The ringer volume is at its
lowest setting.
The listening volume is at
its highest or lowest setting.
Any key is pressed while
the headset is out of range
Two low beeps Call waiting alert tone.
Two rapid beeps
every 20 seconds
Low battery warning.
Three rising beeps A conference call starts.
Three rapid beeps
every 20 seconds
The headset is out of range.
The headset is not yet
registered.
Ring tone Incoming call alert tone.
Ring back tone.
Three rapid beeps The headset is powering on
or off.
Install the battery
NOTE
The battery is permanently attached to the battery
compartment cover (known as the battery pack). Do
not try to separate them from each other.
Install the battery as shown below.
NOTES
Connect and charge the battery
NOTES
Use only the supplied adaptor.
Charge the battery provided with or identified for
use with this product only in accordance with the
instructions and limitations specified in this manual.
Connect the charger
Charge the battery
The light turns on when the headset is
charging.
NOTES
For best performance, keep the headset in the
charger when not in use.
The battery is fully charged after three hours of
continuous charging.
When fully charged, the headset battery provides
approximately 12 hours of talk time or 5 days of
standby time.
Before use
Add and register a headset
NOTE
Charge the new headset without interruption for
at least 30 minutes before registering it to the
telephone base.
To register a headset:
1. Remove the headset from the charger.
2. Press Menu at the telephone base when idle.
3. Press q to highlight User Settings, and then
press SELECT.
4. Press q to highlight DECT headset, and
then press SELECT.
5. With Register highlighted, press SELECT on
the telephone base.
6. Place the headset back to the charger. The
light flashes quickly in red and blue.
The light turns red when the headset is
registered but not fully charged, or turns blue
when it is registered and fully charged.
To verify the registration, press the button on the
headset and check for a dial tone. If the
registration fails, the light on the headset flashes
slowly in red and blue.
To reset the headset, remove it from the headset
charger and repeat the registration process
again.
Deregister a headset
To replace a headset or register the headset to
another telephone base, you must deregister
all devices, and then register each device
individually.
To deregister all devices:
1. Press Menu at the telephone base when idle.
2. Press q to highlight User Settings, and then
press SELECT.
3. Press q to highlight DECT headset, and
then press SELECT.
4. Press q to highlight Deregister, and then
press SELECT.
The light flashes slowly in red and blue when
the deregistration process is successful.
Position the headset
Earbud
There are three sizes of earbuds provided. The
medium-sized earbud is already attached to the
headset.
To remove the earbud from the headset
earpiece:
Hold both sides of the earbud. Twist and
pull the earbud until it separates from the
earpiece.
To attach the earbud to the headset
earpiece:
1. Choose an appropriate earbud.
2. Position the earbud on the earpiece.
3. Press the earbud down on the earpiece until
it clicks into place. Move the earbud around
so that the protruding bump on the earbud is
pointing towards your mouth when placed in
your ear.
Over the ear hook
There are two sizes of ear hooks. You can
choose the suitable ear hook to attach to the
headset.
To adjust the headset to wear on the left or
right ear:
To attach the ear hook to the headset:
1. Remove any headset attachment (earbud
excluded) currently connected to the headset.
2. Insert the earpiece into the ear hook ring.
3. Press the edge of the ear hook ring towards
the earpiece until it clicks into place.
4. Hook the headset onto the desired ear.
Adjust the angle of the headset until the
microphone is pointing towards your mouth.
To remove the ear hook from the headset:
Hold the headset with one hand. Twist and
pull the ear hook with your other hand until it
separates from the earpiece.
Over the head band
To attach the head band to the headset:
1. Remove any headset attachment (earbud
excluded) currently connected to the headset.
2. Insert the earpiece into the loop of the ear pad.
3. Push the earpiece towards the loop of the
ear pad until it clicks into place.
4. Adjust the head band to fit your head. Adjust
and rotate the angle of the headset until the
microphone is pointing towards your mouth.
To remove the head band from the
headset:
Hold the headset with one hand and the ear
pad with your other hand. Twist and pull the
headset until it separates from the loop of the
ear pad.
User’s manual
Battery pack
(with battery
compartment cover
attached)
Headset charger
power adapter
Earbud x5 Over the ear hook
x2
Over the head band Behind the neck
band
User’s manual
1
2
3
4
5
6
1
2
3
To wear on the
left ear
To wear on the
right ear
Your headset package contains the following
items. Save your sales receipt and original
USER'S GUIDE
PLEASE READ THIS USER'S GUIDE BEFORE USING THE HEADSET
Alcatel IP70H
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Alcatel IP70H bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Alcatel IP70H in de taal/talen: Engels als bijlage per email.

De handleiding is 1,71 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Alcatel IP70H

Alcatel IP70H Gebruiksaanwijzing - Deutsch - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info