496518
50
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
If the unit fails to perform as it is supposed to, by following this operation manual, please check it carefully in accordance with the chart below:
11
‘“*C There is no sound.
, q?
The power cord is not connected properly.
Ill
An incorrect function selector button is pressed.
~,
&&Bf,
m,.
~~h-
There is a bad connection between systems.
Ml,&
II
~.m s
a
Excessive voltage was applied to a speaker jack,
.; *
which tripped the amplifier’s voltage-protection
breaker.
There is no sound and no
There is a shorl circuit in the speaker jack.
~a indicators are lit in the display
I
The breaker tripped because of connection to a low-
impedance speaker.
##l Sound comes from only one
I
Onespeakeris disconnected.
constant, wavelike static, I
The antenna is not connected properly.
U!M
I * The receiver is not correctlv tuned.
* The signal is too weak. -
c The system picks up outside noise.
The soun”d is distorted.
= There is multipath distortion.
p,
~sl The tape does not run.
Deck 2 is on pause.
rl
‘“? The sound is off-balance.
@
The playback head is dirty.
,##” High sounds are too loud.
The DOLBY NR mode is set differently from when
M%{
I the recordina was done
p
*-&j
;; There are no high sounds.
A non-Dolby NR tape is being played back in that
m
mode.
~(~g
I The Edavback head is dirtv.
1
Recording is impossible.
* The erasure-prevention tab on the tape has been
I broken.
~~q
I There is an incorrect connection.
~~f I The recording head is dirty.
Erasure is impossible.
The erasure head is dirty.
The disc is incorrectly inserted.
Rmm
,.
I
]
The disc is dirty.
Bma
I
14
‘!
& j
. There is condensation on the disc.
,Z,
The player is on pause.
/,,,,,.
&& The output sound is not stereo.
J&
The VOCAL FADER is turned on,
Correct the connection.
Press the function selector button to select the
correct input.
Correct the connection.
Disconnect the power cord, correct the condition,
including speaker connections, and connect the
power cord again.
. Disconnect the power cord, correct the condition,
including speaker connections, and connect the
power cord a~ain.
Correct the speaker connection.
Check the antenna connection.
Correct the tuning.
Install an outside antenna,
Change the location or direction of the antenna.
Turn the system to a different orientation.
Move the system away from other electrical
appliances, like a TV or fluorescent lights, or move
the appliances.
Change the orientation of the antenna.
Replace the antenna with one that has the correct
orientation.
Press 11and release t)ause.
Clean the head.
Reset DOLBY NR to the same setting as when the
recording was made.
Turn off DOLBY NR.
Clean the head.
c Cover the erasure-prevention hole well with tape.
Correct the connection.
Clean the head.
Clean the erasure head.
Insert the disc with the label facina uo
Clean the disc.
Wait about an hour and try again.
Press 11PAUSE to release ~ause.
Turn off the VOCAL FADER.
50
50

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Aiwa NSX-332 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Aiwa NSX-332 in de taal/talen: Engels, Frans, Spaans als bijlage per email.

De handleiding is 30,74 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info