14
RD6000 Super HELI FEATURES
FEATURES
STW (Stopwatch)
REV (Reverse)
D/R (Dual Rate)
CNT (Center)
TRM (Trim)
EXP (Exponential)
EPA (End Point Adjustment)
M-SL (Model Select)
MOD (Modulation)
TYP (Type of Model)
INT (Integral Timer)
RST (Reset)
CLK (Click)
NAM (Name)
SW-R (Switch Reverse)
CPY (Copy)
T-CUT (Throttle Cut)
DTM (Dynamic Trim Memory)
GYR (Gyro)
CV-P# (Throttle Curve)
CV-P# (Pitch Curve)
RV (Revolution Mixing)
FAIL (Fail Safe)
C-MIX (Compensation Mixing)
STEP (Trim Step)
B-F-S (Battery Fail Safe)
SWH (Cyclic Type)
BASIC ( ON/OFF)
OPT (Option Menu)
DESCRIPTION
Used as a stopwatch or to countdown to a preset time.
Reverses the servo operating direction.
Adjusts servo throw. On Elev, Ail and (Rud in Heli Mode)
Changes servo neutral position.
The LCD provides an indicator of the value, as well as the direction of the trim.
Changes the linear movement of the servo to the relation of the stick movement. Can
be set Positive or Negative.
Limits the total movement of a servo in each direction.
Select models 1, 2, 3, 4, 5, 6, 7, 8.
Transmitting Modulation PPM/FM, PPM/Reverse FM, PCM1, PCM2.
Model Type Aircraft or Helicopter.
Used to show how long the transmitter has been in use. Can be reset to zero.
Clears all setup data in any model to factory default settings.
A beep sound can be heard every time you press a transmitter key. Options Active or
Inoperative.
You can use up to 3 characters to name your model.
You can reverse to default direction of all control switches.
Copy one model to another.
You can set the point where the throttle can be cut using the throttle cut off button.
Memorizes trims in each flight mode.
Gyro sensitivity for each flight mode
To setup a curve in all flight modes.
To setup a curve in all flight modes.
Tail rotor offset mixing
You can preset a default control input when aircraft loses it’s signal from the
transmitter. Only works with a PCM receiver.
Ability to mix a master channel to another slave channel with a C-MIX switch.
Sets the amount of movement a servo will move with one beep of the trim.
Will bring the throttle servo to idle when the airborne battery reaches a predetermaned
low voltage. Only works with a PCM receiver.
5 Cyclic Options (Normal, CP3F, CP3B, CP4F, CP4B)
Basic menu ON or Off
Advanced program allows you to turn off or on function displays.
