593938
29
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
27
6.0 MAINTENANCE
Before carrying out any maintenance jobs it is obligatory to stop the
machine and disconnect it from the power mains.
1. After the first 50 operating hours and then every 250 operation hours the oil
should be refreshed. Turn off the oil drain plug (o) and also remove the filler cap
(n). Collect the oil. If the oil does not come out any longer, switch on the drain
plug again and refill the oil (through filler cap) until the oil has reached the correct
level.
Compressor with direct drive: the right oil level is between the two marks on the
dipstick.
Compressor with V-belt drive: has an oil inspection glass on the pump. The oil
level should be between the red dot on the inspection glass and the upper side of
the inspection glass.
Always respect the regulations in force for disposing of old oil!
2. Regularly drain condensation water. The drain tap is situated at the bottom of the
tank (l). Draining with pressure in the tank is the easiest way. Some compressors
have an after cooler with its own drain plug. Also from this device the
condensation water should be drained regularly (is not valid for the H 85).
Condensate must be disposed of in conformity with the local regulations in
force (not in the sewer!).
As an alternative you can place an oil/water separator.
3. The oil level should also be checked regularly. For the right oil level see point 1. If
necessary refill with AIRPRESS compressor oil, order No 36398 (1/2 l) or order
No 36380 (2 l). Checking daily can prevent a lot of troubles!
Use oil of the same type as that already in the machine; do not mix different
types of oil!
4. The air filter element (m) should be cleaned or changed regularly. This change
depends on the amount of fouling and should be done more often in dusty
situations and less often in a clean situation. For cleaning the filter element, take
out the filter container with the filter. Then clean the filter by blowing off the dust.
Only for compressor with V-belt drive:
5. The V-belt should be checked after every 1000 hours. At the right tension, the V-
belt can easily be turned 45 degrees by hand. If tension is too high, strong
corrosion will occur or eventually the spindle of motor or pump may break. At too
little tension, the efficiency of the compressor decreases considerably.
Tightening the V-belt as follows:
Dismount the belt protector (r).
29

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Airpress 36546 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Airpress 36546 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 1,63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info