729487
9
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
Push brush above and below the boiler damper so that
flash etc. is pushed onto oven top. Insert rake through
hotplate plug aperture and pull deposits into firebox (after
resetting cooker/boiler damper knob to ‘C’).
Replace flue chamber door and hotplate plug and riddle
the bottomgrate thoroughly to clear the bottomgrate
ready for relighting.
NOTE: THE APPLIANCE IS DESIGNED AND
INTENDED TO BE UNDER CONTINUOUS FIRING BUT
IF IT IS NOT IN USE ASHPIT AND FLUE CHAMBER
DOORS SHOULD BE LEFT OPEN TO ENSURE FREE
PASSAGE OF AIR THROUGH THE APPLIANCE AND
AVOID CONDENSATION PROBLEMS.
Sweep annually and inspect soot box at 3 monthly
intervals and remove any deposits.
NOTE: SWEEPS BRUSHES MUST BE OF THE TYPE
WITH WIRE CENTRES AND GUIDE WHEELS.
Prevention: Chimney fires do not occur in clean, intact,
properly installed chimneys. Have a professional
chimney sweep clean and inspect your appliance at least
once a year. More frequent cleanings may be required,
based on the type of fuel burned, the type of appliance,
and the frequency of use. In general, an older appliance
or one that is used frequently, will require more than one
clean per year.
Detection: The first indication of a chimney fire is usually
the noise - a roaring sound grows louder as the fire’s
intensity increases. Clouds of black smoke and sparks
will be seen exiting the top of the chimney; in severe
fires, flames can extend several feet about the chimney.
Action: In case of a chimney fire follow these steps but
do not put yourself or others in peril:
1. Call the fire brigade immediately.
2. Get everyone out of the property.
3. Close down the air supply to the appliance i.e. the
primary air spinner and the flue damper. Limiting the
fires air supply will reduce its intensity. If there is a
damper in the chimney connector, plug or close the
opening.
4. If a fire extinguisher is available, open the appliance
door just enough to insert the nozzle of a 10lb, dry
chemical fire extinguisher rated for Class ABC fires.
Discharge the entire content of the fire extinguisher
into the appliance and shut the door.
5. If possible, wet down the roof and other outside
combustibles to prevent fires ignited by shooting
sparks and flames.
6. Closely monitor all combustible surfaces near the
chimney. During severe chimney fires, these surfaces
can become hot enough to ignite.
After a chimney fire, have the chimney inspected by a
professional chimney sweep or cooker installer.
Surface blemishes caused by spillage on the gloss
enamel are easier to remove when the cooker is cool,
and a damp cloth is usually all that is necessary.
This should not be done whilst the cooker is hot.
DO NOT USE ABRASIVE PADS, OVEN CLEANER, OR
CLEANERS CONTAINING CITRIC ACID ON
ENAMELLED SURFACES.
IMPORTANT NOTE: Aga recommend Vitreous Enamel
Association approved cleaners for cleaning the vitreous
enamelled surfaces of this product.
But they are unsuitable for use on: chrome and stainless
steel components, including the hand-rails and their
brackets.
The insulating covers should be cleaned regularly with a
NON-ABRASIVE mild detergent, applied with a soft
(coarse free) cloth and lightly polished up afterwards with
a soft (coarse free) duster or tissue to bring it back to its
original lustre.
Allow fire to burn out first then open the ashpit door and
lift off the clinker door. Remove dead fuel with hooked
poker into ashpan and then lift up each individual bar,
pulling forward to remove.
NOTE: THERE ARE TWO TYPES OF BARS
ASSEMBLED AND THE REPLACEMENT BARS
SHOULD BE CHECKED AGAINST ‘REPLACED’ BAR
BEFORE REPLACEMENT.
The firebricks fitted to the Rayburn 355SFW are of first
quality manufacture, and providing the cooker has been
installed and used correctly will have a reasonable life.
They are, however, expendable items and in time will
require renewal.
Replacement bricks either in sets or singly can be
obtained from your Rayburn distributor. Always quote the
manufacturing number.
The manufacturing number, which will be found fixed to
the appliance, should be quoted if any question arises in
connection with the Rayburn 355SFW Cooker.
Three grate plates are supplied for WOOD BURNING
ONLY. These plates are designed to sit on top of the
reciprocating firebars with the return edge downwards.
They provide a solid flat surface for the wood to burn on
and are NOT TO BE USED
when burning solid mineral
fuels. These plates may distort but will only need
replacing if they are damaged or missing.
TO REPLACE BOTTOMGRATE BARS
FIREBRICK REPLACEMENT
GRATE PLATE REPLACEMENT
9
CHIMNEY SWEEPING
CHIMNEY FIRES
CLEANING
9

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Aga-Rayburn-355SFW

Zoeken resetten

  • Goede middag Ll, graag zouden e de meest eenvoudige aansluitschema willen van de Rayburn 355 sFW zodat we verder kunnen Gesteld op 15-5-2024 om 12:11

    Reageer op deze vraag Misbruik melden
  • Ik probeer te achterhalen wat het rendement is van de Aga Rayburn 355 fsw. Ik kan het nergens gevonden krijgen. Kan iemand mij helpen? Vriendelijke groet Peer. Gesteld op 13-1-2024 om 11:01

    Reageer op deze vraag Misbruik melden
  • Goedemiddag, ik zou graag de handleiding voor de Rayburn Heatranger 355SFW in het Nederlands hebben. Ik probeer het met vertalen, maar krijg het er dan niet lekker uit, is er een andere manier om het wel goed uit te pringen. M.vr.gr., Carolien Gesteld op 28-4-2021 om 14:38

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Aga Rayburn 355SFW bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Aga Rayburn 355SFW in de taal/talen: Engels als bijlage per email.

De handleiding is 0,27 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info