NOTE: FOR MODELS WITH GREEN BAND GRAPHICS ON CONTROL KNOB ‘B’. (SEE FIG.
3A).
CAUTION: BEFORE LIGHTING: ENSURE KNOB (A) IS IN THE OFF POSITION (SEE FIG. 9).
ALSO ENSURE GAS SUPPLY TO COOKER IS ON, AND THE SERVICE GAS COCK (C) IS
IN THE ON POSITION (SEE FIG. 2), AND THE ELECTRICAL SUPPLY TO THE AGA IS
SWITCHED ON.
LIGHTING PROCEDURE - SEE FIGS 9 - 14
1. The main burner gas flow is set with the ‘temperature knob’ (B) (See Fig. 3A). First
ensure both knobs are turned fully clockwise. Knob (A) to the OFF position and knob (B) to
the minimum setting (thin end of white band).
2. Turn ‘ON/OFF’ knob (A) slightly anti-clockwise towards the ignition position ( ) until
reaching stop, press down and hold for 5 seconds (gas flows only to the pilot burner) (See
Fig. 10).
3. Continue pressing down knob (A) while turning further anti-clockwise to the PILOT position
(See Fig. 11) (this activates the piezo) continue to hold down for 10 seconds after pilot burner
has been lit. (If the pilot does not light, steps 2 and 3 can be repeated).
4. Upon lighting, release knob and turn further anti-clockwise to the ‘ON’ position (large flame
symbol) (See Fig. 12). Pilot gas flows and mains gas flows according to the temperature
setting (knob B).
5. Turn the temperature knob (B) slightly anti-clockwise into the white band (LOW FIRE
position) (See Fig. 13). Leave in the low fire position for at least 30 minutes
.
NOTE: Low fire position is attained by turning knob (B) gradually into the white band until small
flame is observed through viewing window (D).
6. After 30 minutes rotate control knob (B) anti-clockwise to the mid-position of the green band
for normal running (See Fig. 14).
NOTE: After several hours the heat indicator should be on or about the centre of the silver
section. It may be necessary to adjust the control knob in the green band to achieve this.
When the cooker is lit from cold, moisture may form on the enamel which should be wiped off to
prevent staining.
IF THE FLAME HAS EXTINGUISHED FOR ANY REASON, WAIT THREE MINUTES
(MINIMUM) BEFORE RE-LIGHTING.
TO LIGHT THE BURNER
8
